Technical Information
EiceDRIVER™ 2ED300C17-S
preliminary
Passing on of this document or its contents to company external personnel requires written consent.
Usage and copying of the contents to other media is prohibited. Violations will be prosecuted for
damages. All rights reserved, including such arising from issue of patents or registration of trade marks or
design.
© eupec GmbH 2002. All rights reserved.
Correspondence of the contents of this document with the described hardware has been checked.
Discrepancies may exist nevertheless; no guaranty is assumed for total congruence. The information
contained in this document is subject to regular revision. Any alterations required will be incorporated in
the next issue. Suggestions for improvement are welcome. Changes of the document may occur without
prior notice.
Safety notice!
It must be prevented that children and the general public have access to the installed driver or can get into
proximity!
The driver may only be used for the purposes prescribed by the manufacturer. Inadmissible alterations
and use of spare parts and accessories not recommend by the manufacturer of the driver can cause fire,
electric shock and injuries.
This document has to be at the disposal of all users, developers and qualified personnel who are to work
with the driver.
If measurements and tests on the live device have to be carried out, then the regulations of the Safety
Code VBG 4.0 are to be observed, in particular § 8 “Admissible deviations during work on live parts“.
Suitable electronic devices are to be used.
Prior to installation and commissioning please read this document thoroughly.
• Commissioning is prohibited if there is visible damage by inappropriate handling or transport.
• Contact while uninstalled is permitted only with ESD protection.
• Install only without supply voltage.
• Always keep sufficient safety distance during commissioning without closed protective housing.
• Contact under live condition is strictly prohibited.
• Work after turn-off is not admissible until the absence of supply voltage has been verified.
• During work after turn-off it has to be observed that components heat up during operation. Contact
with these can cause burning.
• The drivers are mounted electrically and mechanically into a mother board by soldering. The mechanical
strength has to be verified by the user and, if necessary, assured with appropriate tests.
• The drivers are designed for use with eupec IGBT Modules type IHM, EconoPACK+, 62mm. In case of
ulterior use, safe operation cannot be guaranteed.
Page 2
www.eupec.com
www.EiceDRIVER.com
EUPEC [ EUPEC GMBH ]
