ELM322
AT Commands (continued)
SR hh
[ Set the Receive address to hh ]
Depending on the application, users may wish to
manually set the address to which the ELM322 will
respond. Issuing this command will turn off the AR
mode, and force the IC to only accept responses
addressed to hh. This could be useful in non-OBD
applications, or simply while experimenting with a
network.
ELM322 AT Commands
general
D set all to Defaults
I show the ID string
Z reset all
ST hh
[ Set Timeout to hh ]
After sending a request, the ELM322 waits a preset
time before declaring that there was no response
from the vehicle (the ‘NO DATA’ response).
Depending on the application (and priority of the
request), users may want to modify this timeout
period before the ELM322 declares that the request
was a failure. The ST command is used to do that.
<CR> repeat last command
responses
E1/0 Echo on/off
The actual time used is (approximately) 4 ms x the
byte value passed as the hexadecimal argument.
Passing a value of FF thus results in a maximum
time of about 1020 ms. Values less than 08 will be
ignored and forced to a value of 8, providing a
minimum time of 32 ms. The default value is 32
(decimal 50) providing a timeout of 200 ms.
H1/0 Headers on/off
L1/0 Linefeeds on/off
R1/0 Responses on/off
PD use Packed Data
FD use Formatted Data
ST hh Set Timeout (hh*4ms)
requests
Z
[ reset all ]
SH xx yy zz Set Header
SR hh Set Rx address
AR Auto Receive
MA Monitor All
MR hh Monitor for Rxer hh
MT hh Monitor for Txer hh
This command causes the chip to perform a
complete reset, as if power were cycled off and then
on again. All settings are returned to their default
values, and the chip will be put in the idle state,
waiting for characters on the RS232 bus.
AT Command Summary
Figure 1. ELM322 AT Commands
Figure 1 (at the right) shows all of the ELM322
commands in one convenient chart. In order to help
with the understanding of these, we have grouped
the commands into three functional areas, but this
has no bearing on how the commands should be
used, it is only for clarity. You may find this chart to
be useful when experimenting with the IC.
ELM322DSF
Elm Electronics – Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
7 of 18
ELM [ ELM ELECTRONICS ]
