ELM322
Absolute Maximum Ratings
Storage Temperature....................... -65°C to +150°C
Note:
Stresses beyond those listed here will likely damage
the device. These values are given as a design
guideline only. The ability to operate to these levels
is neither inferred nor recommended.
Ambient Temperature with
Power Applied....................................-40°C to +85°C
Voltage on VDD with respect to VSS............0 to +7.5V
Voltage on any other pin with
respect to VSS........................... -0.6V to (VDD + 0.6V)
Electrical Characteristics
All values are for operation at 25°C and a 5V supply, unless otherwise noted. For further information, refer to note 1 below.
Characteristic
Minimum Typical
Maximum Units
Conditions
Supply voltage, VDD
VDD rate of rise
4.5
5.0
5.5
V
see note 2
see note 3
0.05
V/ms
mA
Average supply current, IDD
1.0
2.4
Input low voltage
Input high voltage
Output low voltage
Output high voltage
Rx pin input current
RS232 baud rate
VSS
0.15 VDD
VDD
V
V
0.85 VDD
0.6
V
Current (sink) = 8.7 mA
Current (source) = 5.4 mA
see note 4
VDD - 0.7
-0.5
V
+0.5
mA
baud
see note 5
9600
Notes:
1. This integrated circuit is produced with a Microchip Technology Inc.’s PIC12C509A as the core embedded
microcontroller. For further device specifications, and possibly clarification of those given, please refer to the
appropriate Microchip documentation (available at http://www.microchip.com/).
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as
may be obtained through direct connection to solar cells, or some charge pump circuits.
3. Device only. Does not include any load currents.
4. This specification represents the current flowing through the internal protection diodes when the voltage
connected to the Rx input (through a current limiting resistance) is greater than VDD or less than VSS.
Currents quoted are the maximum that should be allowed to flow continuously.
5. Nominal data transfer rate when a 3.58 MHz crystal is used as the frequency reference. Data is transferred
to and from the ELM322 with 8 data bits, no parity, and 1 stop bit (8 N 1).
3 of 18
ELM322DSF
Elm Electronics – Circuits for the Hobbyist
< http://www.elmelectronics.com/ >
ELM [ ELM ELECTRONICS ]
