24LLC02
2K-Bits Serial EEPROM For Low Power
VCC WP SCL SDA
24LLC02
A0
A1
A2
VSS
NOTE:
The 24LLC02 is available in 8-pin DIP, SOP,TSSOP package.
Figure 1-2. Pin Assignment Diagram
Table 1-1. 24LLC02 Pin Descriptions
Type
Name
Description
Circuit
Type
A0, A1, A2
Input
Input pins for device address selection. To configure a device address,
these pins should be connected to the VCC or VSS of the device.
1
These pins are internally pulled down to VSS
.
VSS
–
Ground pin.
–
3
SDA
I/O
Bi-directional data pin for the I2C-bus serial data interface. Schmitt
trigger input and open-drain output. An external pull-up resistor must
be connected to VCC. Typical values for this pull-up resistor are 4.7 kW
(100 kHz) and 1 kW(400 kHz).
SCL
WP
Input
Input
Schmitt trigger input pin for serial clock input.
Input pin for hardware write protection control. If you tie this pin to VCC,
2
1
the write function is disabled to protect previously written data in the
entire memory; if you tie it to VSS , the write function is enabled.
This pin is internally pulled down to V
.
SS
VCC
–
Single power supply.
–
NOTE : See the following page for diagrams of pin circuit types 1, 2, and 3.
* All specs and applications shown above subject to change without prior notice.
1F-5 NO.66 SEC.2 NAN-KAN RD ., LUCHU , TAOYUAN, TAIWAN
Tel:886-3-3214525
Email: server@ceramate.com.tw
Http: www.ceramate.com.tw
Rev 1.0 Dec. 26, 2001
Page 3 of 19
Fax:886-3-3521052
CERAMATE [ CERAMATE TECHNICAL ]
