EXTERNAL DATACLK
BASIC OPERATION
Figure 1b shows a basic circuit to operate the ADS7813 with
a ±10V input range. To begin a conversion, a falling edge
must be provided to the CONV input. BUSY will go LOW
indicating that a conversion has started and will stay LOW
until the conversion is complete. Just prior to BUSY rising
near the end of the conversion, the internal working register
holding the conversion result will be transferred to the
internal shift register.
INTERNAL DATACLK
Figure 1a shows a basic circuit to operate the ADS7813 with
a ±10V input range. To begin a conversion and serial
transmission of the results from the previous conversion, a
falling edge must be provided to the CONV input. BUSY
will go LOW indicating that a conversion has started and
will stay LOW until the conversion is complete. During the
conversion, the results of the previous conversion will be
transmitted via DATA while DATACLK provides the syn-
chronous clock for the serial data. The data format is 16-bit,
Binary Two’s Complement, and MSB first. Each data bit is
valid on both the rising and falling edge of DATACLK.
BUSY is LOW during the entire serial transmission and can
be used as a frame synchronization signal.
The internal shift register is clocked via the DATACLK
input. The recommended method of reading the conversion
result is to provide the serial clock after the conversion has
completed. See External DATACLK under the Reading
Data section of this data sheet for more information.
C1
C2
ADS7813
0.1µF 10µF
+5V
±10V
1
2
3
4
5
6
7
8
R1IN
GND
R2IN
R3IN
BUF
CAP
REF
GND
VS 16
PWRD 15
BUSY 14
CS 13
+
Frame Sync (optional)
Convert Pulse
CONV 12
EXT/INT 11
DATA 10
+
C3
C4
0.01µF
1µF
+
C5
1µF
40ns min
DATACLK
9
FIGURE 1a. Basic Operation, ±10V Input Range, Internal DATACLK.
C1
C2
ADS7813
0.1µF 10µF
+5V
±10V
1
2
3
4
5
6
7
8
R1IN
GND
R2IN
R3IN
BUF
CAP
REF
GND
VS 16
PWRD 15
BUSY 14
CS 13
+
Interrupt (optional)
Chip Select (optional(1)
)
Convert Pulse
CONV 12
EXT/INT 11
DATA 10
+
C3
C4
0.01µF
+5V
1µF
+
40ns min
C5
1µF
External Clock
DATACLK
9
NOTE: (1) Tie CS to GND if the outputs will always be active.
FIGURE 1b. Basic Operation, ±10V Input Range, External DATACLK.
ADS7813
SBAS043C
7
www.ti.com
BB [ BURR-BROWN CORPORATION ]
