8#0#9##2SHUDWLQJ#'HVFULSWLRQ
When a trip occurs a status message is flashed (de-coded by the above table 5.2).
When the RUN command is removed the status message will stop flashing if the
alarm has cleared. This will bring low control terminal 10 if Healthy/Unhealthy has
been selected parameter P14 = 0. This places the product into a state where the RUN
command can be re-applied and if the alarm does not reoccur the product will run
normally.
5HVHW#WR#)DFWRU\#'HIDXOW#9DOXHV
All parameters can be returned to factory default settings by powering up the 601
while both
keys are pressed simultaneously.
',$*1267,&6
7LWOH
'HVFULSWLRQ
FREQUENCY. This diagnostic gives the current output frequency in
Hz.
ë
SET POINT. This diagnostic gives the set point frequency in Hz.
LOAD. This diagnostic gives current load value as % of 601 rating.
7DEOH#816
ê
é
6(/(&7,1*#$1'#23(5$7,1*#/2&$/#02'(
To select Local mode press
simultaneously from the status level and
stopped. The display will begin to spell OìFðûWhen all three letters are displayed
and the word ORF is flashing release the
keys or the display will revert
back to Ud\ (remote mode). The display now shows the local setpoint which can be
E
increased using the
or decreased using the
key. The
(green) key can
M
be used to start the 601 and the
the stopped state pressing the
(red) key can be used to stop the 601. While in
M
key will show the current direction. This
M
direction may be changed by holding down the
key while simultaneously
key for (reverse).
pressing either the
key for
(forward) or the
)
(8
M
To clear a fault, press
.
To return to Ud\û(remote mode) press
and
simultaneously. For safety, the
drive will not return to the remote mode if this will cause the drive to start. In this
event the display will flash. Check RUN and JOG inputs are low.
(1*/,6+
934#0##+$79784;
ETC [ ETC ]
