Z8 Encore!® Motor Control Flash MCUs
Product Specification
260
Table 139. DC Characteristics (Continued)
T = –40ºC to 105ºC
A
2
Symbol Parameter
Minimum Typical Maximum Units Conditions
I
I
Tri-State Leakage Current
Weak Pull-up Current
–5
9
—
+5
50
µA
µA
V
= 3.3V.
TL
DD
20
V
= 2.7–3.6V.
PU1
DD
T = 0ºC to +70ºC.
A
I
Weak Pull-up Current
7
20
2
75
µA
V
A
= 2.7–3.6V.
DD
PU2
T = –40ºC to +105ºC.
Idd
Chip leakage current in
STOP mode
uA STOP mode with VBO
disabled, WDT enabled.
stop1
Idd
Chip leakage current in
STOP mode
<1
uA STOP mode with VBO
and WDT disabled.
stop2
Notes:
1. This condition excludes all pins that have on-chip pull-ups, when driven Low.
2. These values are provided for design guidance only and are not tested in production.
Figure 45 illustrates the typical active mode current consumption while operating at 25ºC,
3.3V, versus the system clock frequency. All GPIO pins are configured as outputs and
driven High.
Figures 45 through 50 are not yet available. At this time, the Z8FMC16100 Series Flash
MCU is not fully characterized.
Note:
Electrical Characteristics
P R E L I M I N A R Y
PS024604-1005
ZILOG [ ZILOG, INC. ]
