Z8 Encore! XP® F08xA Series
Product Specification
9
Table 3. Signal Descriptions
Description
Signal Mnemonic
I/O
General-Purpose I/O Ports A–D
PA[7:0]
PB[7:0]
I/O
I/O
Port A. These pins are used for general-purpose I/O.
Port B. These pins are used for general-purpose I/O. PB6 and PB7 are
available only in those devices without an ADC.
PC[7:0]
PD[0]
I/O
I/O
Port C. These pins are used for general-purpose I/O.
Port D. This pin is used for general-purpose output only.
Note: PB6 and PB7 are only available in 28-pin packages without ADC. In 28-pin packages with ADC,
they are replaced by AV and AV
.
DD
SS
UART Controllers
TXD0
RXD0
CTS0
DE
O
I
Transmit Data. This signal is the transmit output from the UART and IrDA.
Receive Data. This signal is the receive input for the UART and IrDA.
Clear To Send. This signal is the flow control input for the UART.
I
O
Driver Enable. This signal allows automatic control of external RS-485
drivers. This signal is approximately the inverse of the TXE (Transmit
Empty) bit in the UART Status 0 register. The DE signal may be used to
ensure the external RS-485 driver is enabled when data is transmitted by
the UART.
Timers
T0OUT/T1OUT
T0OUT/T1OUT
O
O
Timer Output 0–1. These signals are output from the timers.
Timer Complement Output 0–1. These signals are output from the timers
in PWM Dual Output mode.
T0IN/T1IN
I
Timer Input 0–1. These signals are used as the capture, gating and
counter inputs. The T0IN signal is multiplexed T0OUT signals.
Comparator
CINP/CINN
I
Comparator Inputs. These signals are the positive and negative inputs to
the comparator.
COUT
O
Comparator Output. This is the output of the comparator.
Analog
ANA[7:0]
I
Analog Port. These signals are used as inputs to the analog-to-digital
converter (ADC). The ANA0, ANA1 and ANA2 pins can also access the
inputs and output of the integrated transimpedance amplifier.
VREF
I/O
Analog-to-digital converter reference voltage input.
PS024705-0405
P R E L I M I N A R Y
Pin Description
ZILOG [ ZILOG, INC. ]
