欢迎访问ic37.com |
会员登录 免费注册
发布采购

Z0221524ASCR4508TR 参数 Datasheet PDF下载

Z0221524ASCR4508TR图片预览
型号: Z0221524ASCR4508TR
PDF下载: 下载PDF文件 查看货源
内容描述: 单芯片调制解调器,集成控制器,数据泵和模拟前端 [Single Chip Modem with Integrated Controller, Data Pump, and Analog Front End]
分类和应用: 调制解调器控制器
文件页数/大小: 74 页 / 663 K
品牌: ZILOG [ ZILOG, INC. ]
 浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第53页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第54页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第55页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第56页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第58页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第59页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第60页浏览型号Z0221524ASCR4508TR的Datasheet PDF文件第61页  
Z02215  
Single Chip Modem with Integrated Controller, Data Pump, and AFE  
51  
Country Configuration  
The Z02215 contains modem controller code that is targeted to operate over a  
North America-style telephone network with the DAA configuration illustrated in  
the schematics at the end of this product specification. The customer may choose  
to configure the modem for use on other telephone networks. This capability is  
enabled by the addition of a serial EEPROM to hold various country tables. The  
EEPROM may be omitted from the application if the customer chooses to operate  
with the default North America-style parameters.  
If an EEPROM is not desired, the country table can also be downloaded to the  
Z02215 from the host and stored in on-board RAM.  
The Z02215 provides a means of loading information into the EEPROM for setting  
homologation or country approval tables. One way to set these tables is by choos-  
ing the desired geographic region to be served in a DOS program, supplied by  
ZiLOG, called Diplomat. This program interfaces to the modem through the  
serial port using hidden AT commands, allowing reprogramming of the EEPROM.  
Typical Performance Data  
The Bit Error Rate (BER) and Block Error Rate (BLER) curves in Figure 6 are rep-  
resentative of a typical V.22 and V.22bis performance over a variety of signal-to-  
noise ratio (SNR) conditions.  
Modems usually exhibit lower bit error rates receiving in the low  
band as opposed to the high band.  
Note:  
For each BER curve illustrated, one connection is made, after which the Adaptive  
Equalizer (AEQ) was frozen. BER measurements are taken in 1 dB SNR steps  
from low noise levels to high noise levels. These tests were conducted using a  
Consultronics TCS500 Telephone Line Simulator and a Hewlett Packard 4951B  
protocol analyzer/BERT tester, under the following conditions:  
Line Simulation  
Transmit Level  
Receive Level  
Data Transmitted  
Number of Bits Sent  
Bits per Block  
AEQ  
Flat  
–10 dBm  
–30.0 dBm  
511 pseudorandom pattern  
10,000,000 in V.22bis, V.22 and Bell 212A.  
1,000  
Frozen after link establishment  
C-message  
Noise Calibration  
PS001907-0904  
Country Configuration  
 复制成功!