MT88L70
Pin Description
Pin #
18
17
20
19
Name
St/GT
Description
Data Sheet
Steering Input/Guard time (Output) Bidirectional.
A voltage greater than V
TSt
detected at
St causes the device to register the detected tone pair and update the output latch. A voltage
less than V
TSt
frees the device to accept a new tone pair. The GT output acts to reset the
external steering time-constant; its state is a function of ESt and the voltage on St.
Positive power supply (Input).
+3 V typical.
No Connection.
18
20
7, 16
V
DD
NC
Functional Description
The MT88L70 monolithic DTMF receiver offers small size, low power consumption and high performance, with 3
volt operation. Its architecture consists of a bandsplit filter section, which separates the high and low group tones,
followed by a digital counting section which verifies the frequency and duration of the received tones before passing
the corresponding code to the output bus.
Filter Section
Separation of the low-group and high group tones is achieved by applying the DTMF signal to the inputs of two
sixth-order switched capacitor bandpass filters, the bandwidths of which correspond to the low and high group
frequencies. The filter section also incorporates notches at 350 and 440 Hz for exceptional dial tone rejection. Each
filter output is followed by a single order switched capacitor filter section which smooths the signals prior to limiting.
Limiting is performed by high-gain comparators which are provided with hysteresis to prevent detection of
unwanted low-level signals. The outputs of the comparators provide full rail logic swings at the frequencies of the
incoming DTMF signals.
Decoder Section
Following the filter section is a decoder employing digital counting techniques to determine the frequencies of the
incoming tones and to verify that they correspond to standard DTMF frequencies. A complex averaging algorithm
protects against tone simulation by extraneous signals such as voice while providing tolerance to small frequency
deviations and variations. This averaging algorithm has been developed to ensure an optimum combination of
immunity to talk-off and tolerance to the presence of interfering frequencies (third tones) and noise. When the
detector recognizes the presence of two valid tones (this is referred to as the “signal condition” in some industry
specifications) the “Early Steering” (ESt) output will go to an active state. Any subsequent loss of signal condition
will cause ESt to assume an inactive state (see “Steering Circuit”).
Steering Circuit
Before registration of a decoded tone pair, the receiver checks for a valid signal duration (referred to as character
recognition condition). This check is performed by an external RC time constant driven by ESt. A logic high on ESt
causes v
c
(see Figure 3) to rise as the capacitor discharges. Provided signal condition is maintained (ESt remains
high) for the validation period (t
GTP
), v
c
reaches the threshold (V
TSt
) of the steering logic to register the tone pair,
latching its corresponding 4-bit code (see Table 1) into the output latch. At this point the GT output is activated and
drives v
c
to V
DD
. GT continues to drive high as long as ESt remains high. Finally, after a short delay to allow the
output latch to settle, the delayed steering output flag (StD) goes high, signalling that a received tone pair has been
registered. The contents of the output latch are made available on the 4-bit output bus by raising the three state
control input (TOE) to a logic high. The steering circuit works in reverse to validate the interdigit pause between
signals. Thus, as well as rejecting signals too short to be considered valid, the receiver will tolerate signal
interruptions (dropout) too short to be considered a valid pause. This facility, together with the capability of selecting
3
Zarlink Semiconductor Inc.
ZARLINK [ ZARLINK SEMICONDUCTOR INC ]
