欢迎访问ic37.com |
会员登录 免费注册
发布采购

MT8888CE 参数 Datasheet PDF下载

MT8888CE图片预览
型号: MT8888CE
PDF下载: 下载PDF文件 查看货源
内容描述: 集成双音多频收发器与英特尔微型接口 [Integrated DTMF Transceiver with Intel Micro Interface]
分类和应用:
文件页数/大小: 25 页 / 537 K
品牌: ZARLINK [ ZARLINK SEMICONDUCTOR INC ]
 浏览型号MT8888CE的Datasheet PDF文件第6页浏览型号MT8888CE的Datasheet PDF文件第7页浏览型号MT8888CE的Datasheet PDF文件第8页浏览型号MT8888CE的Datasheet PDF文件第9页浏览型号MT8888CE的Datasheet PDF文件第11页浏览型号MT8888CE的Datasheet PDF文件第12页浏览型号MT8888CE的Datasheet PDF文件第13页浏览型号MT8888CE的Datasheet PDF文件第14页  
MT8888C  
Data Sheet  
The lookup table contains codes which are used by the switched capacitor D/A converter to obtain discrete and  
highly accurate DC voltage levels. Two identical circuits are employed to produce row and column tones, which  
are then mixed using a low noise summing amplifier. The oscillator described needs no “start-up” time as in other  
DTMF generators since the crystal oscillator is running continuously thus providing a high degree of tone burst  
accuracy. A bandwidth limiting filter is incorporated and serves to attenuate distortion products above 8 kHz. It can  
be seen from Figure 8 that the distortion products are very low in amplitude.  
Scaling Information  
10 dB/Div  
Start Frequency = 0 Hz  
Stop Frequency = 3400 Hz  
Marker Frequency = 697 Hz and  
1209 Hz  
Figure 10 - Spectrum Plot  
8.0 Burst Mode  
In certain telephony applications it is required that DTMF signals being generated are of a specific duration  
determined either by the particular application or by any one of the exchange transmitter specifications currently  
existing. Standard DTMF signal timing can be accomplished by making use of the Burst Mode. The transmitter is  
capable of issuing symmetric bursts/pauses of predetermined duration. This burst/pause duration is 51 ms±1 ms,  
which is a standard interval for autodialer and central office applications. After the burst/pause has been issued, the  
appropriate bit is set in the Status Register indicating that the transmitter is ready for more data. The timing  
described above is available when DTMF mode has been selected. However, when CP mode (Call Progress mode)  
is selected, the burst/pause duration is doubled to 102 ms ±2 ms. Note that when CP mode and Burst mode have  
been selected, DTMF tones may be transmitted only and not received. In applications where a non-standard  
burst/pause time is desirable, a software timing loop or external timer can be used to provide the timing pulses  
when the burst mode is disabled by enabling and disabling the transmitter.  
10  
Zarlink Semiconductor Inc.