MA17503
6.0 ABSOLUTE MAXIMUM RATINGS
Note: Stresses above those listed may cause permanent
damage to the device. This is a stress rating only and
functional operation of the device at these conditions, or at
any other condition above those indicated in the operations
section of this specification, is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect device reliability.
Parameter
Min
-0.5
-0.3
-20
-55
-65
Max
7
Units
V
Supply Voltage
Input Voltage
VDD+0.3
+20
V
Current Through Any Pin
Operating Temperature
Storage Temperature
mA
°C
125
150
°C
Table 8: Absolute Maximum Ratings
7.0 DC ELECTRICAL CHARACTERISTICS
Total Dose Radiation Not
Exceeding 3x105 Rad(Si)
Symbol Parameter
Conditions
Min
Typ
Max
Units
VDD
VIHC
VILC
VIHT
VILT
VOHC
VOLC
VOHT
VOLT
IL
Supply Voltage
VSS = 0
4.5
5.0
5.5
-
V
V
CMOS Input High Voltage (Note 1)
CMOS Input Low Voltage (Note 1)
TTL Input High Voltage (Note 2)
TTL Input Low Voltage (Note 2)
-
-
-
-
VDD-1
-
-
-
-
-
-
-
-
-
-
5
-
VSS+1
-
V
2.0
V
-
0.8
-
V
CMOS Output High Voltage (Note 1) IOH = -1.4mA, VDD = 4.5V
4.0
V
CMOS Output Low Voltage (Note 1)
TTL Output High Voltage (Note 2)
TTL Output Low Voltage (Note 2)
Input Leakage Current (Note 3)
Output Leakage Current (Note 3)
Operating Supply Current
IOL = 2mA, VDD = 5.5V
-
0.5
-
V
IOH = -1.4mA, VDD = 4.5V
IOL = 2mA, VDD = 5.5V
3.5
V
-
-
-
-
0.4
±10
±50
14
V
VDD = 5.5V, VIN = 0V or 5.5V
VDD = 5.5V, VO = 0V or 5.5V
µA
µA
mA
IOZ
IDDOP
VDD = 5.5V,
SYNCLKN = 4MHz
IDDST
Static Supply Current
VDD = 5.5V,
-
3
10
mA
SYNCLKN = 0MHz
Mil-Std-883, Method 5005, Subgroup 1, 2, 3.
Notes: 1. The following signals are CMOS compatible:
a) CMOS inputs: INTREN, Microcode Bus, (M04, M05, M06), HLDAKN and SYNCLK.
b) CMOS outputs: PIFN, IRN and IRDYN.
2. The following signals are TTL compatible:
a) DTIMERN, TGCLK, MPROEN, DMAPEN, EXADEN, PIOXEN, FLT7N, SYSFN, OVIN, PWRDN, INT02N,
INT08N,INT10N, INT11N, INT12N/IOI1N, INT13N, INT14N/IO12N, INT15N, DTON, DSN, M/ION, DMARN,
TCLK and MSTOPN.
b) TTL outputs: SURE, NPU, DDN, TGON, CDN, PAUSED, ILLADN, CONFIG, DMAKN and DMAE.
c) TTL I/O signal: Address/Data Bus (AD00-AD15).
3. Worst case at TA = +125°C, guaranteed but not tested at TA = -55°C.
Table 9: DC Electrical Characteristics
26
ZARLINK [ ZARLINK SEMICONDUCTOR INC ]
