欢迎访问ic37.com |
会员登录 免费注册
发布采购

YB1880 参数 Datasheet PDF下载

YB1880图片预览
型号: YB1880
PDF下载: 下载PDF文件 查看货源
内容描述: 独立线性锂离子电池充电器 [Standalone Linear Lithium Battery Charger]
分类和应用: 电池
文件页数/大小: 10 页 / 615 K
品牌: YOBON [ YOBON TECHNOLOGIES,INC. ]
 浏览型号YB1880的Datasheet PDF文件第1页浏览型号YB1880的Datasheet PDF文件第3页浏览型号YB1880的Datasheet PDF文件第4页浏览型号YB1880的Datasheet PDF文件第5页浏览型号YB1880的Datasheet PDF文件第6页浏览型号YB1880的Datasheet PDF文件第7页浏览型号YB1880的Datasheet PDF文件第8页浏览型号YB1880的Datasheet PDF文件第9页  
YB1880  
Standalone Linear Lithium Battery Charger  
Pin Configuration  
Figure 2: Pin Configuration  
Pin Description  
Table 1  
Pin Number Pin Name  
Description  
Open-Drain Charge Status Output. When the battery is charging, the CHRG pin is  
pulled low by an internal N-channel MOSFET. When the charge cycle is completed,  
a weak pull-down of approximately 20mA is connected to the CHRG pin, indicating  
an “AC present” condition. When the YB1880 detects an under voltage lockout  
condition, CHRG is forced high impedance.  
1
CHRG  
2
3
GND  
BAT  
Ground  
Charge Current Output. Provides charge current to the battery and regulates the  
final float voltage to 4.2V. An internal precision resistor divider from this pin sets the  
float voltage which is disconnected in shutdown mode.  
Positive Input Supply Voltage. Provides power to the charger. VCC can range from  
4.25V to 6.5V and should be bypassed with at least a 1mF capacitor. When VCC  
drops to within 30mV of the BAT pin voltage, the  
4
VCC  
YB1880 enters shutdown mode, dropping IBAT to less than 2mA.  
Charge Current Program, Charge Current Monitor and Shutdown Pin. The charge  
current is programmed by connecting a 1% resistor, RPROG, to ground. When  
charging in constant-current mode, this pin servos to 1V. In all modes, the voltage  
on this pin can be used to measure the charge current using the following formula:  
IBAT = (VPROG/RPROG) • 1000  
5
PROG  
The PROG pin can also be used to shut down the charger. Disconnecting the  
program resistor from ground allows a 3mA current to pull the PROG pin high.  
When it reaches the 1.21V shutdown threshold voltage, the charger enters  
shutdown mode, charging stops and the input supply current drops to 25mA. This  
pin is also clamped to approximately 2.4V. Driving this pin to voltages beyond the  
clamp voltage will draw currents as high as 1.5mA. Reconnecting RPROG to  
ground will return the charger to normal operation.  
Ordering Information  
Order Number  
Package Type  
Supplied As  
Package Marking  
Please contact sales  
representative  
YB1880ST25P  
SOT23-5  
3000 units Tape & Reel  
YB1880 Rev.1.0  
www.yobon.com.tw  
2
 复制成功!