CA SERIES
BLOCK DIAGRAM
OPTIONS
OPTION
POLARITY DESIGNATOR
INPUT VOLTAGE
TEMPERATURE
POSITIVE OUTPUT
NEGATIVE OUTPUT
5 VDC
12 VDC (STANDARD)
STANDARD OPERATING TEMP -10º TO +50ºC
*6
(CASE TEMP.)
ORDER CODE
p
N
5
BLANK
BLANK
HOW TO ORDER
PART NUMBER SELECTOR:
Model Number:
CA 10 N - 5
CA -
Model
10 -
Output Voltage (See table)
5 -
Input Voltage
N -
Polarity Designator
EXAMPLE:
CA10N-5
(CA - Model,
10
- Output Voltage,
N
- Negative,
5
- Input Voltage)
* Notes:
1. Maximum rated output current is typically available from 100% max output voltage to 50% max output voltage,
and is derated below 50% max output voltage.
2. Specifications after 1 hour warm-up, full load, at 25oC unless other wise indicated.
3. Typical Performance
4. All grounds internally connected, except case. There should not be more than 50 volts potential between the case ground (pin 5) and
the circuit ground (pins 3 and 8). Isolated case assists low noise design efforts. Case pin must be connected to ground for proper
operation. For ultra-low noise applications the case can be grounded to a low noise shielding ground.
5. On negative output models, voltage monitor output is a buffered representation of the programming voltage.
6. Proper thermal management techniques are required to maintain safe case temperature at maximum power output.
7. SET POINT ACCURACY refers to the ability of the unit to accurately deliver the voltage intended by the applied programming.
The resultant output voltage will be within +/-1% of that programmed.
GAIN ADJUSTMENT refers to the ability to alter the gain of the circuit to bring the resultant output voltage to the programmed setpoint.
This is intended to allow compensation for set point accuracy error.
LINEARITY refers to how much the transfer function can deviate from a straight line in the absence of any set point error.
XP-EMCO reserves the right to make changes on products and literature, including specifications, without notice. XP-EMCO standard product models are not recommended for “copy-exact” applications or any other application restricting product changes. “Copy-exact” options
are available. Please contact an XP-EMCO sales representative for more details.
WWW.XPPOWER.COM
4709CA02
PAGE 7
XPPOWER [ XP POWER LIMITED ]
