AG Series
1 & 1.5 Watt
• Output voltages from 100V to 6000V
• Output Proportional to Input
• 0.7VDC Turn-on Voltage
• Extremely Low Profile <0.25”
• Surface Mount
• Input to Output Isolation
• Short Circuit Protection
• Control Pin
• No minimum load
• 3 Year Warranty
DC-HVDC Converter
xxx Series
Dimensions:
All models:
Height x Width: 0.25 x 0.45" (6.35 x 11.43mm)
100V to 2000V outputs:
Length: 0.92" (23.37mm)
3000V to 5000V outputs:
Length: 1.13" (28.69mm)
Dimensions do not include the surface mount tabs, see mechanical details.
The AG Series is a broad line of ultra-miniature DC to HV DC converters that sets an industry standard
in high voltage miniaturization. This unique package occupies less than one tenth of a cubic inch of
volume and an extremely low profile of only 0.128 inches (3.25mm) when mounted in from the top, or
0.152 (3.86mm) when mounted in from the bottom of the PCB. They can also mount off the PCB
with .030” diameter pins. They are offered in 1 watt or 1.5 watt power ratings, with output voltages
ranging from 100 volts to 6000 volts. The output is directly proportional to the input voltage and is
linear from <0.7V input to maximum input voltage. Output is load dependent. Isolation permits <±500V
bias on output return. No external components or minimum load are required.
A separate high impedance control pin is standard and is designed for external error amplifier and/or
DAC control in closed or open loop systems, or simply connect the control pin to the + input for
proportional input to output operation. Use of a resonant, quasi-sinewave oscillator and fully shielded
transformer result in clean, reliable high voltage conversion with inherently low ripple, EMI/RFI and
input ripple current, making this product ideal for integration into noise sensitive equipment.
6000V outputs:
Length: 1.33" (33.78mm)
Key Applications:
•
•
•
•
•
•
•
Avalanche Photo Diodes
Photo Multiplier Tubes
Electrophoresis
Capacitor Charging
Sustaining Ion Pumps
Piezo Devices
Handheld Instruments
Input
Characteristic
Input Voltage
Input Current
Control Voltage Input
Minimum
0.7
Typical
Maximum
5,12,24
550
Units
VDC
mA
Notes & Conditions
See Models and Ratings Table.
See Models and Ratings Table.
Analog Control Voltage adjusts output from 0 to 100%, not to exceed Input Voltage, see Application Notes.
Output
Characteristic
Output Voltage
Output Current
Output Voltage Tolerance
Minimum Load
Regulation
Short Circuit Protection
Ripple and Noise
+10, -10
No minimum load required
Unregulated, Output is proportional to Input. See Application Notes.
Protected against short circuit conditions for a minimum 1 minute.
0.3
5
%
See Models and Ratings Table.
Minimum
Typical
Maximum
6,000
15
Units
VDC
mA
%
Notes & Conditions
See Models and Ratings Table
See Models and Ratings Table
At Max Vout, Full Load
Notes
1. Maximum output current is available at maximum rated output voltage, and
derates linearly as input voltage is decreased.
2. Output Voltage is load dependent. Under light or no-load conditions, reduce
the Input Voltage so maximum rated Output Voltage is not exceeded.
3. Specifications are after 30 minute warm-up, full-load at 25°C, unless otherwise
noted.
4. Proper thermal management techniques are required to maintain safe case
temperature at maximum power output.
1
www.xppower.com
XPPOWER [ XP POWER LIMITED ]
