X9241
PIN DESCRIPTIONS
PIN NAMES
Symbol
Description
Serial Clock
Host Interface Pins
Serial Clock (SCL)
SCL
SDA
Serial Data
Address
The SCL input is used to clock data into and out of the
X9241.
A0–A3
V
H0
–V V –V
L3
Potentiometers
H3, L0
(terminal equivalent)
Serial Data (SDA)
V
–V
Potentiometers
W0
W3
SDA is a bidirectional pin used to transfer data into and
out of the device. It is an open drain output and may be
wire-ORed with any number of open drain or open
collector outputs. An open drain output requires the use
of a pull-up resistor. For selecting typical values, refer
to the guidelines for calculating typical values on the
bus pull-up resistors graph.
(wiper equivalent)
3864 PGM T01
PRINCIPLES OF OPERATION
TheX9241isahighlyintegratedmicrocircuitincorporat-
ing four resistor arrays, their associated registers and
counters and the serial interface logic providing direct
Address
2
communicationbetweenthehostandtheE POTpoten-
The Address inputs are used to set the least significant
4 bits of the 8-bit slave address. A match in the slave
address serial data stream must be made with the
Address input in order to initiate communication with the
X9241.
tiometers.
Serial Interface
The X9241 supports a bidirectional bus oriented proto-
col. The protocol defines any device that sends data
ontothebusasatransmitterandthereceivingdeviceas
the receiver. The device controlling the transfer is a
master and the device being controlled is the slave. The
master will always initiate data transfers and provide the
clock for both transmit and receive operations. There-
fore, the X9241 will be considered a slave device in all
applications.
Potentiometer Pins
V (V – V ), V (V – V )
H
H0
H3
L
L0
L3
The VH and VL inputs are equivalent to the terminal
connections on either end of a mechanical potentiom-
eter.
V
W
(V – V
)
W3
W0
Clock and Data Conventions
The wiper outputs are equivalent to the wiper output of
a mechanical potentiometer.
Data states on the SDA line can change only during
SCL LOW periods (t
). SDA state changes during
LOW
SCL HIGH are reserved for indicating start and stop
conditions.
PIN CONFIGURATION
DIP/SOIC/TSSOP
Start Condition
All commands to the X9241 are preceded by the start
condition, which is a HIGH to LOW transition of SDA
VW0
VL0
VH0
A0
1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
V
CC
VW3
VL3
VH3
A1
while SCL is HIGH (t
). The X9241 continuously
HIGH
monitors the SDA and SCL lines for the start condition
and will not respond to any command until this condition
is met.
A2
X9241
VW1
VL1
VH1
SDA
A3
Stop Condition
SCL
VW2
VL2
VH2
All communications must be terminated by a stop con-
dition, which is a LOW to HIGH transition of SDA while
SCL is HIGH.
V
SS
3864 ILL F01A.2
2
XICOR [ XICOR INC. ]
