Production Data
WM8782
Test Conditions
AVDD = 5V, DVDD = 3.3V, AGND = DGND = 0V, TA = +25°C
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
TYP
MAX
UNIT
Power Supply Input Timing Information
DVDD level to activate POR
– power on
Vpora
Vpora
Vpora
Vporr
Vporr
Vporr
tpor
Measured from DGND
Measured from AGND
Measured from AGND
Measured from DGND
Measured from AGND
Measured from AGND
0.7
0.7
V
V
AVDD level to activate POR –
power on
VMID level to activate POR –
power on
0.7
V
DVDD level to release POR –
power on (see notes 1 and 2)
DVDD Min
AVDD Min
1
V
AVDD level to release POR –
power on (see notes 1 and 2)
V
VMID level to release POR –
power on (see notes 1 and 2)
V
POR active period (see notes
1 and 2)
Measured from POR
active to POR release
30
Defined by DVDD/AVDD/
VMID Rise Time
0.8
µs
(note 6)
DVDD level to activate POR
– power off (see note 5)
Vpor_off
Vpor_off
Vpor_off
tpon
Measured from DGND
Measured from AGND
Measured from AGND
V
V
AVDD level to activate POR –
power off (see note 5)
0.8
0.7
30
VMID level to activate POR –
power off (see note 5)
V
Power on - POR propagation
delay through device
Measured from rising
EDGE of POR
µs
µs
Power down - POR
propagation delay through
device
tpoff
Measured from falling
EDGE of POR
30
Notes:
1. POR is activated when DVDD or AVDD or VMID reach their stated Vpora level (Figure 10).
2. POR is only released when DVDD and AVDD and VMID have all reached their stated Vporr levels (Figure 10).
3. The rate of rise of VMID depends on the rate of rise of AVDD, the internal 50kΩ resistance and the external
decoupling capacitor. Typical tolerance of 50K resistor can be taken as +/-20%.
4. If AVDD, DVDD or VMID suffer a brown-out (i.e. drop below the minimum recommended operating level but do
not go below Vpor_off,), then the chip will not reset and will resume normal operation when the voltage is back to
the recommended level again.
5. The chip will enter reset at power down when AVDD or DVDD or VMID falls below Vpor_off. This may be important
if the supply is turned on and off frequently by a power management system.
6. The minimum tpor period is maintained even if DVDD, AVDD and VMID have zero rise time. This specification is
guaranteed by design rather than test.
PD, August 2006, Rev 4.2
15
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
