WM8728
Production Data
SELECTION OF LRCIN POLARITY
In left justified, right justified or I2S modes, the LRP register bit controls the polarity of LRCIN. If
this bit is set high, the expected polarity of LRCIN will be the opposite of that shown in Figure 10,
Figure 11 and Figure 12. Note that if this feature is used as a means of swapping the left and right
channels, a 1 sample phase difference will be introduced.
REGISTER ADDRESS
0011
BIT
LABEL
DEFAULT
DESCRIPTION
1
LRP
0
LRCIN Polarity (normal)
0 : normal LRCIN polarity
1: inverted LRCIN polarity
Interface Control
Table 16 LRCIN Polarity Control
In DSP modes, the LRCIN register bit is used to select between early and late modes (see Figure
13 and Figure 14.
REGISTER ADDRESS
0011
BIT
LABEL
DEFAULT
DESCRIPTION
1
LRP
0
DSP Format (DSP modes)
0 : Late DSP mode
Interface Control
1: Early DSP mode
Table 17 DSP Format Control
In DSP early mode, the first bit is sampled on the BCKIN rising edge following the one that
detects a low to high transition on LRCIN. In DSP late mode, the first bit is sampled on the BCKIN
rising edge, which detects a low to high transition on LRCIN. No BCKIN edges are allowed
between the data words. The word order is DIN left, DIN right.
ATTENUATOR CONTROL MODE
Setting the ATC register bit causes the left channel attenuation settings to be applied to both left
and right channel DACs from the next audio input sample. No update to the attenuation registers
is required for ATC to take effect.
REGISTER ADDRESS
0011
BIT
LABEL
DEFAULT
DESCRIPTION
2
ATC
0
Attenuator Control Mode:
0 : Right channels use Right
attenuation
Interface Control
1: Right Channels use Left
Attenuation
Table 18 Attenuation Control Select
OUTPUT PHASE REVERSAL
The REV register bit controls the phase of the output signal. Setting the REV bit causes the
phase of the output signal to be inverted.
REGISTER ADDRESS
0011
BIT
LABEL
DEFAULT
DESCRIPTION
Analogue Output Phase
0: Normal
4
REV
0
Interface Control
1: Inverted
Table 19 Output Phase Control
BCKIN POLARITY
By default, LRCIN and DIN are sampled on the rising edge of BCKIN and should ideally change
on the falling edge. Data sources which change LRCIN and DIN on the rising edge of BCKIN can
be supported by setting the BCP register bit. Setting BCP to 1 inverts the polarity of BCKIN to the
inverse of that shown in Figure 10, Figure 11, Figure 12, Figure 13 and Figure 14.
REGISTER ADDRESS
0011
BIT
LABEL
DEFAULT
DESCRIPTION
BCKIN Polarity
5
BCP
0
0 : normal BCKIN polarity
1: inverted BCKIN polarity
Interface Control
Table 20 BCKIN Polarity Control
PD, Rev 4.6, August 2008
24
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
