欢迎访问ic37.com |
会员登录 免费注册
发布采购

WM8501_09 参数 Datasheet PDF下载

WM8501_09图片预览
型号: WM8501_09
PDF下载: 下载PDF文件 查看货源
内容描述: 24位192kHz的立体声DAC,具有1.7Vrms线路驱动器 [24-bit 192kHz Stereo DAC with 1.7Vrms Line Driver]
分类和应用: 驱动器
文件页数/大小: 20 页 / 285 K
品牌: WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
 浏览型号WM8501_09的Datasheet PDF文件第2页浏览型号WM8501_09的Datasheet PDF文件第3页浏览型号WM8501_09的Datasheet PDF文件第4页浏览型号WM8501_09的Datasheet PDF文件第5页浏览型号WM8501_09的Datasheet PDF文件第7页浏览型号WM8501_09的Datasheet PDF文件第8页浏览型号WM8501_09的Datasheet PDF文件第9页浏览型号WM8501_09的Datasheet PDF文件第10页  
WM8501  
Production Data  
ELECTRICAL CHARACTERISTICS  
Test Conditions  
AVDD = 5V, DVDD = 3.3V, GND = 0V, TA = +25oC, fs = 48kHz, MCLK = 256fs unless otherwise stated.  
PARAMETER  
SYMBOL  
TEST CONDITIONS  
MIN  
TYP  
MAX  
UNIT  
Digital Logic Levels (TTL Levels)  
Input LOW level  
VIL  
VIH  
0.8  
V
V
Input HIGH level  
2.0  
Output LOW  
VOL  
VOH  
I
OL = 2mA  
DGND + 0.3V  
V
V
Output HIGH  
I
OH = 2mA  
DVDD – 0.3V  
Analogue Reference Levels  
Reference voltage (VMID)  
Potential divider resistance  
AVDD/2  
50  
V
RCAP  
AVDD to VMID and  
VMID to GND  
kΩ  
DAC Output (Load = 10kΩ. 50pF)  
0dBFs Full scale output voltage  
At DAC outputs  
1.6 x  
AVDD/5  
1.7 x  
AVDD/5  
100  
1.8 x  
AVDD/5  
Vrms  
dB  
Signal to Noise Ratio (Note  
5,6,7)  
SNR  
A-weighted,  
@ fs = 48kHz  
A-weighted  
@ fs = 96kHz  
A-weighted  
90  
97  
97  
dB  
dB  
@ fs = 192kHz  
Dynamic Range (Note 2, 6)  
DNR  
THD  
A-weighted, -60dB full  
scale input  
90  
100  
-88  
dB  
Total Harmonic Distortion  
(Note 7)  
1kHz, Load = 10kΩ,  
-78  
dB  
0dBFS  
DAC channel separation  
Analogue Output Levels  
Output level (line output)  
93  
dB  
Load = 10kΩ, 0dBFS  
1.7  
Vrms  
Minimum resistance load (line  
output)  
To midrail or a.c.  
coupled  
820  
Ω
Output level (Headphone output)  
Load = 16Ω, 0dBFS  
To midrail or a.c.  
coupled  
1.0  
16  
Vrms  
Minimum resistance load  
(Headphone output)  
Ω
Gain mismatch  
channel-to-channel  
±1  
%FSR  
V
Output d.c. level  
AVDD/2  
Supply Current  
Analogue supply current  
Digital supply current  
AVDD = 5V  
DVDD = 5V  
9
8
mA  
mA  
mA  
mA  
DVDD = 3.3V  
AVDD=DVDD=5V  
4.5  
0.01  
Power down current (note 4)  
Notes:  
1. Ratio of output level with 1kHz full scale input, to the output level with all zeros into the digital input, measured ‘A’ weighted  
over a 20Hz to 20kHz bandwidth.  
2. All performance measurements done with 20kHz low pass filter, and where noted an A-weight filter. Failure to use such a  
filter will result in higher THD and lower SNR and Dynamic Range readings than are found in the Electrical Characteristics.  
The low pass filter removes out of band noise; although it is not audible it may affect dynamic specification values.  
3. VMID pin decoupled with 10uF and 0.1uF capacitors (smaller values may result in reduced performance).  
4. Power down occurs 1.5μs after MCLK is stopped.  
5. Signal-to-noise ratio (dB) – SNR is a measure of the difference in level between the full scale output and the output with  
no signal applied. (No Auto-zero or Automute function is employed in achieving these results).  
PD, Rev 4.2, July 2009  
w
6