Production Data
WM8326
33 REVISION HISTORY
DATE
REV
DESCRIPTION OF CHANGES
CHANGED
BY
Initial version created.
October 2010
October 2010
26/01/2011
1.0
1.0
1.1
PH
PH
PH
CLKIN renamed as TEST
SDOUT1 description amended to Open Drain, with external pull-up required.
Default value of PWRSTATE_DLY corrected.
Alternative 2.2uH recommended inductor quoted for DC1, DC2.
Undervoltage margin specified for all DC-DC converters.
Overvoltage margin specified for DC-DC converters 1, 2.
Chip Temperature (AUX_DATA) equation updated.
Added notes that SLEEP > OFF is not a controlled transition; converters and
regulators are disabled immediately.
07/03/11
1.1
PH
RESET pin description updated to note integrated pull-up.
IRQ description updated to note pull-up in Open Drain mode.
System Reset and Device Reset descriptions updated, consistent with the
Summary Table.
Recommended external pull-up resistances added in Pin Description.
Internal pull-up / pull-down resistances added in Electrical Characteristics.
Noted Active High (non-inverted) polarity for GPIO “Power On/Off request”
function is not fully supported in development mode.
Noted maximum limit on Software Resets. Also clarification of the maximum
number of Watchdog / Undervoltage Device Resets.
2.0
PH
Correction to DBVDD test conditions (Section 7.7).
RTC_PINT_FREQ definition updated.
DC-DC output inductor saturation limit recommendations added.
SYSOK_THR register description updated.
Quiescent current characteristics updated for DC-DC 1-4.
DC1/2 output current rating reduced to 1250mA in 4MHz mode.
Backup battery power updated; Charger control registers deleted.
LDO11 output amended for LDO11_VSEL_SRC=1 and DC-DC1 disabled.
OTP Register Map overview correction (GPn_TRI replaced with GPn_ENA).
15/09/11
2.0
PH
LDO11 maximum output current increased (only for PVDD ≥ 3.1V).
01/12/11
01/02/12
2.1
2.1
PH
PH
Electrical Characteristics updated.
DC3_STNBY_LIM, DC4_STNBY_LIM descriptions updated.
SYSOK_THR description updated.
Product status changed to Pre-Production.
07/03/12
25/06/12
3.0
4.0
PH
Product status changed to Production Data
JMacD
PD, June 2012, Rev 4.0
255
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
