ISD4004 SERIES
Notes:
[1]
Typical values @ TA = 25°C, VCC = 3.0V and timing measurement at 50% of Vcc level.
[2]
All Min/Max limits are guaranteed by Winbond via electrical testing or characterization. Not all
specifications are 100 percent tested.
[3]
[4]
Low-frequency cutoff depends upon the value of external capacitors (see Pin Descriptions)
Single-ended input mode. In the differential input mode, VIN maximum for ANA IN+ and ANA IN- is 16
mVp-p.
[5]
[6]
[7]
Sampling Frequency can vary as much as ±2.25 percent over the commercial temperature and voltage
ranges, and –6/+4 percent over the extended temperature, industrial temperature and voltage ranges.
For greater stability, an external clock can be utilized (see Pin Descriptions)
Playback and Record Duration can vary as much as ±2.25 percent over the commercial temperature and
voltage ranges, and –6/+4 percent over the extended temperature, industrial temperature and voltage
ranges. For greater stability, an external clock can be utilized (see Pin Descriptions)
Filter specification applies to the antialiasing filter and the smoothing filter. Therefore, from input to
output, expect a 6 dB drop by nature of passing through both filters.
The typical output voltage will be approximately 450 mVp-p with VIN at 32 mVp-p.
For optimal signal quality, this maximum limit is recommended.
When a record command is sent, TRAC = TRAC + TRACL on the first row address.
Measured with AutoMute feature disabled.
[8]
[9]
[10]
[11]
- 24 -
WINBOND [ WINBOND ]
