5962-9559507HBC 参数 Datasheet PDF下载

MIL-HDBK-103AP

6. DISTRIBUTION AND REQUESTS

6.1 Distribution. Requests for individual drawings and revisions to existing drawings may be addressed to:

DLA Land and Maritime

ATTN: VAC

3990 E. Broad Street

Columbus, OH 43218-3990

Autovon 850-0547

Commercial (614) 692-0547

6.1.1 Automatic distribution. To be added to a mailing list for automatic distribution of new drawings and revisions to existing

drawings requests may be addressed to:

DLA Land and Maritime

ATTN: VAS

3990 E. Broad Street

Columbus, OH 43218-3990

Autovon 850-8478

Commercial (614) 692-8478

6.1.2 Electronic distribution. Electronic copies of Standard Microcircuit Drawings are available on the World Wide Web at

http://www.landandmaritime.dla.mil/Programs/MilSpec.

6.2 Requests. Requests for copies may be available online at

or

or from the

Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,Philadelphia, PA 19111-5094

7. NOTES

7.1 Intended use. This list has been prepared for use by or for the Government in the acquisition of products covered by

SMDs. Listing of a product is not intended to and does not connote endorsement of the product by the Department of

Defense. This list is subject to change without notice; revision or amendment of this list will be issued as necessary. This

listing supersedes the approved source of supply listing in the individual Standard Microcircuit Drawings, however the listing of

a product does not release the supplier from compliance with the SMD requirements.

7.2 Subject item (key word) listing.

Part or identifying number (PIN)

Drawing number

Device class designator

Drawing requirements

Preparation procedures

Drawing effectivity and duration

Approved sources of supply

Radiation hardness assurance (RHA) levels

Electrostatic discharge sensitivity (ESD) listing

Configuration management of SMDs

Noun code descriptions

7.3 Changes from previous issue. Marginal notations are not used in this revision to identify Changes with respect to the

previous issue due to the extent of the changes.

4