MIL-HDBK-103AP
1.2.3 Case outline/lead finish. Case outline and lead finish are as described in each SMD. The lead finish indicated in the
section 1 Part I listing is the most readily available from the manufacturer listed for the part. The manufacturer is authorized to
supply other lead finishes than what is listed provided that further testing/qualification is performed by the manufacturer on the
other lead finish(es). The user needs to contact the manufacturer to determine the availability of other lead finishes not listed
herein.
1.2.4 Substitutability. Device-class-Q devices will replace device-class-M devices.
2. APPLICABLE DOCUMENTS This section is not applicable to the handbook.
3. DEFINITIONS This section is not applicable to the handbook.
4. REQUIREMENTS
4.1 Drawing requirements. SMD's will be prepared in accordance with ASME Y14.100 and DOD directives.
4.2 Preparation procedures. The procedures for the generation of an SMD are provided in MIL-HDBK-780.
4.3 Drawing effectivity and duration. SMD's and device class M one part - one part number SMDs which have become
inactive for new design are reflected in section 1, part 1 of the appendix of this document with an "I" in the status column.
4.4 Approved sources of supply. The approved sources of supply list in this handbook supersedes the approved sources
formerly listed in each individual SMD/DLA Land and Maritime Drawing. This handbook is the official list of approved sources
of supply for non-one part - one part number SMD PIN's and for device class M one part - one part number SMD PIN's. Device
classes B, S, Q, V, T, N (monolithic) and H, K, D, G, E (hybrid) one part - one part number SMD PIN's are listed for the
convenience of the users. Official listing for B, S, Q, V, T, N, H, K, D, G, and E levels are available in the applicable QML.
Manufacturers should notify DLA Land and Maritime-VA in writing if they no longer wish to be listed as an approved source of
supply for any device listed herein. This letter will be used by DSCC to remove the manufacturer from MIL-HDBK-103 for
those devices that the manufacturer specifies that he will no longer supply.
4.5 Radiation hardness assurance (RHA) levels. SMD devices which meet the RHA requirements of MIL-PRF-38535 or
MIL-PRF-38534 will be marked with the appropriate RHA designator M, D, P, L, R, F, G, or H replacing the dash (-) in the PIN
as indicated in the following example:
5962(M, D, P, L, R, F, G, or H)8999901EA
Only the highest RHA level for which the device is qualified will be listed in Section 1, Part I of the appendix of this document;
however, at the request of the customer, the manufacturer is authorized to supply any lower RHA level device. At the request
of the customer, the non-RHA PIN designated with a dash (-) may be supplied at the option of the manufacturer. The
manufacturer may also opt to submit a certificate of compliance to have the non-RHA PIN listed in addition to the RHA PIN in
Section 1, Part I of the appendix of this document.
2
WEDC [ WHITE ELECTRONIC DESIGNS CORPORATION ]
