MIL-HDBK-103AJ
2.
3.
4.
APPLICABLE DOCUMENTS
DEFINITIONS
REQUIREMENTS
SMD's will be prepared in accordance with ASME Y14.100 and DOD
The procedures for the generation of an SMD are provided in
This section is not applicable to the handbook.
This section is not applicable to the handbook.
4.1 Drawing requirements.
directives.
4.2 Preparation procedures.
MIL-HDBK-780.
4.3 Drawing effectivity and duration. SMD's and device class M one part - one part number SMDs
which have become inactive for new design are reflected in section 1, part 1 of the appendix of this
document with an "I" in the status column.
4.4 Approved sources of supply. The approved sources of supply list in this handbook supersedes the
approved sources formerly listed in each individual SMD/DLA Land and Maritime Drawing. This handbook is the
official list of approved sources of supply for non-one part - one part number SMD PIN's and for device
class M one part - one part number SMD PIN's. Device classes B, S, Q, V, T, N (monolithic) and H, K, D, G, E
(hybrid) one part - one part number SMD PIN's are listed for the convenience of the users. Official listing
for B, S, Q, V, T, N, H, K, D, G, and E levels are available in the applicable QML. Manufacturers should
notify DLA Land and Maritime-VA in writing if they no longer wish to be listed as an approved source of
supply for any device listed herein. This letter will be used by DSCC to remove the manufacturer from
MIL-HDBK-103 for those devices that the manufacturer specifies that he will no longer supply.
4.5 Radiation hardness assurance (RHA) levels. SMD devices which meet the RHA requirements of MIL-PRF-
38535 or MIL-PRF-38534 will be marked with the appropriate RHA designator M, D, P, L, R, F, G, or H replacing
the dash (-) in the PIN as indicated in the following example:
5962(M, D, P, L, R, F, G, or H)8999901EA
Only the highest RHA level for which the device is qualified will be listed in Section 1, Part I of the
appendix of this document; however, at the request of the customer, the manufacturer is authorized to supply
any lower RHA level device. At the request of the customer, the non-RHA PIN designated with a dash (-) may
be supplied at the option of the manufacturer. The manufacturer may also opt to submit a certificate of
compliance to have the non-RHA PIN listed in addition to the RHA PIN in Section 1, Part I of the appendix of
this document.
4.6 Electrostatic discharge sensitivity (ESD) listing. ESD classification levels, as required by
MIL-PRF-38534 or MIL-PRF-38535, will be listed in the status column of section 1, part 1, of the
appendix. Manufacturers are required to send these classification levels to DLA Land and Maritime-VA for all
Standard Microcircuit Drawings for which they are an approved source. The ESD listing in section 1, part 1 of
the appendix will be in accordance with the following:
STATUS
Blank
0
1
1A
1B
1C
2
3
3A
3B
INTERPRETATION
Data not submitted
Class 0; < 250 V
Class 1; 0 – 1999 V
Class 1A; 250 V – 499 V
Class 1B; 500 V – 999 V
Class 1C; 1,000 V – 1999 V
Class 2; 2000 V – 3999 V
Class 3;
≥
4000 V
Class 3A; 4000 V – 7999 V
Class 3B;
≥
8000 V
2
WEDC [ WHITE ELECTRONIC DESIGNS CORPORATION ]
