VITESSE
SEMICONDUCTOR CORPORATION
Low Jitter
Clock Multiplier and Distributor
Table 6: Power Dissipation
Description
I
CC
P
D
Power supply current
Power dissipation
Advance Product Information
VSC6108/10/12
Min
Typ
0.45
1.5
Max
0.6
2
Units
A
Watts
Note: Output power dissipation does not include load power.
Absolute Maximum Ratings
(1)
Power Supply Voltage, (V
CC
) ..........................................................................................................-0.5V to +4.3V
Output Current (I
OUT
) .................................................................................................................................... 50mA
Case Temperature Under Bias (T
C
) ............................................................................................. -55
o
C to + 125
o
C
Storage Temperature (T
STG
) ........................................................................................................ -65
o
C to + 150
o
C
Note: Caution: Stresses listed under “Absolute Maximum Ratings” may be applied to devices one at a time without causing
permanent damage. Functionality at or exceeding the values listed is not implied. Exposure to these values for extended
periods may affect device reliability.
Recommended Operating Conditions
Power Supply Voltage, (V
CC
).................................................................................................................+3.3V+5%
Commercial Operating Temperature Range
(2)
(T) .............................................................................. 0
o
C to 70
o
C
1)
CAUTION: Stresses listed under “Absolute Maximum Ratings” may be applied to devices one at a time without causing per-
manent damage. Functionality at or above the values listed is not implied. Exposure to these values for extended periods may
affect device reliability.
Lower limit of specification is ambient temperature and upper limit is case temperature.
2)
ESD Ratings
Proper ESD procedures should be used when handling this product. The VSC6108, VSC6110 and
VSC6112 are rated to the following ESD voltages based on the human body model:
1. All pins are rated at or above 1500V.
Package Pin Description
Table 7: Package Pin Identification
Pin #
1
2
3
4
5
6
Signal
VREF
FOSEL0
VEE
VEE
FOSEL1
FOSEL2
Signal Type
Power
I
Power
Power
I
I
I/O Type
---
ECL
Comments
-1.32V
-3.3V
-3.3V
Pin Description
Power
Output Frequency Select 0
Negative Supply Voltage
Negative Supply Voltage
Output Frequency Select 1
Output Frequency Select 2
ECL
ECL
Page 4
©
VITESSE
SEMICONDUCTOR CORPORATION
741 Calle Plano, Camarillo, CA 93012 • 805/388-3700 • FAX: 805/987-5896
G52224-0, Rev 2.1
2/15/99
VITESSE [ VITESSE SEMICONDUCTOR CORPORATION ]
