DCM4623xD2H26F0y7z
Electrical Specifications
Specifications apply over all line, trim and load conditions, internal temperature TINT = 25ºC, unless otherwise noted. Boldface specifications apply over the
temperature range of -40°C < TINT < 125°C for T grade and -55°C < TINT < 125°C for M grade.
Attribute
Symbol
Conditions / Notes
Min
200
Typ
300
Max
Unit
Power Input Specification
Input voltage range
VIN
IINRP
Continuous operation
420
V
A
Inrush current (peak)
With maximum COUT-EXT, full resistive load
Effective value at nominal input voltage
At 1 MHz
12.0
Input capacitance (internal)
Input capacitance (internal) ESR
Input inductance (external)
CIN-INT
RCIN-INT
LIN
0.8
µF
2.50
mΩ
µH
Differential mode, with no further line bypassing
No Load Specification
5
Nominal line, see Fig. 3
1.1
2.4
1.8
2.0
3.4
7.5
W
W
W
W
Input power – disabled
PQ
Worst case line, see Fig. 3
Nominal line, see Fig. 4
Input power – enabled with no load
PNL
Worst case line, see Fig. 4
Power Output Specification
Output voltage set point
VOUT-NOM
23.88
24.0
24.12
V
V
Trim range over temp, with > 10% rated load.
Specifies the Low, Nominal and High Trim conditions.
Rated output voltage trim range
VOUT-TRIMMING
21.6
24.0
26.4
0% to 10% load, additional VOUT relative to VOUT
accuracy; see Fig. 5 and Sec. Design Guidelines
Output voltage light load regulation
VOUT accuracy
ΔVOUT-LL
-0.00
-1.0
5.05
1.0
V
The total output voltage setpoint accuracy from the
calculated ideal VOUT based on trim. Excludes ΔVOUT-LL
%VOUT-ACCURACY
%
Rated output power
Rated output current
POUT
IOUT
Continuous, VOUT ≥ 24.0 V
Continuous, VOUT ≤ 24.0 V
600
W
A
25.00
Of rated IOUT max. Fully operational current limit, for
nominal trim and below
Output current limit
Current limit delay
IOUT-LM
100
120
135
%
tIOUT-LIM
The module will power limit in a fast transient event
Full load, nominal line, nominal trim
1
ms
%
%
%
92.8
90.4
90.5
93.6
Efficiency
η
Full load, over line and temperature, nominal trim
50% load, over rated line, temperature and trim
20 MHz bandwidth. At nominal trim, minimum COUT-EXTand
at least 10 % rated load
Output voltage ripple
VOUT-PP
904
mV
Output capacitance (internal)
COUT-INT
Effective value at nominal output voltage
At 1 MHz
42
µF
Output capacitance (internal) ESR
RCOUT-INT
0.069
mΩ
Excludes component temperature coefficient For load
transients that remain > 10% rated load
Output capacitance (external)
Output capacitance (external)
Output capacitance (external)
Output capacitance, ESR (ext.)
COUT-EXT
1000
1000
1000
10
10000
10000
10000
µF
Excludes component temperature coefficient For load
transients down to 0% rated load, with static trim
Excludes component temperature coefficient Forload
transientsdownto0%ratedload,withdynamictrimming
COUT-EXT-TRANS
µF
COUT-EXT-
µF
TRANS-TRIM
RCOUT-EXT
At 10 kHz, excludes component tolerances
mΩ
DCM™ DC-DC Converter
Rev 1.0
Page 5 of 23
12/2017