These boards provide a convenient way to evaluate/demonstrate the performance of Vicor’s DCM
products. Kelvin connections are provided for accurate voltage measurements on power nodes. Sockets
are provided to permit quick installation and changing of bulk filtering capacitors. The evaluation board
also provides lugs for input/output connections, test points and sockets for easy connection to standard
test-equipment, and a high performance air cooled heatsink assembly.
Contents
The evaluation board arrives with the following contents:
ꢀn1 x DCM evaluation board
ꢀn1 x top and belly heatsink assembly (pre-installed)
ꢀn1 x hardware kit
Features
The DCM evaluation board has the following features:
1. Input and output lugs for source and load connections
2. Input fuse (appropriately rated)
3. Basic input filtering, including sockets to add through-hole input aluminum-electrolytic capacitors
for additional source decoupling
Note: The filtering used in the eval board is for demonstration purposes only and might not be the optimal
solution for all applications. For optimal filter design for parallel array application, consult the datasheet of the
DCM in use and the online filter design tool at:
http://app2.vicorpower.com/filterDesign/intiFilter.do
4. Basic output filtering, including sockets to add through-hole output
aluminum-electrolytic capacitors
5. Toggle switch for enabling and disabling the DCM via the ENABLE pin
6. Trim control selection
a. Using potentiometer
b. Using external voltage source
c. Open, to disable trimming and latch the model nominal trim condition
7. Provisions to replace input and output differential mode inductors with wire loops,
for oscilloscope/shunt based current measurements
8. Oscilloscope probe jack for accurate, high frequency output voltage measurements
9. Dual paralleling connectors for ENABLE, TRIM, FAULT and SGND signal connections, for daisy
chaining control to other DCM evaluation boards in an array
10. Kelvin voltage test points for all power pins
11. Top and bottom heatsink assembly for the DCM
UG:017
vicorpower.com
Applications Engineering: 800 927.9474
Page 3
VICOR [ VICOR CORPORATION ]
