W-band Multiplier/MPA
CHU2277a98F
Recommended assembly plan
25µm wedge bonding is preferred
Note: Supply feed should be bypassed. 25µm diameter gold wire is to be preferred.
This drawing shows an example of assembly and bias configuration. All the
transistors are internally self-biased. An external capacitor is recommended for
the positive and negative supply voltages.
For the RF pads the equivalent wire bonding inductance (diameter=25µm) have
to be according to the following recommendation.
Recommended circuit bonding table
Port
Equivalent inductance (nH)
L_in=0.32
Wire length (mm) (1)
IN (2)
0.4
0.4
0.4
OUT1 (5)
OUT2 (8)
L_out1=0.32
L_out2=0.32
(1) This value is the total length including the necessary loop from pad to pad.
For a micro-strip configuration a hole in the substrate is necessary for chip assembly
Ref. : DSCHU2277a0266 - 23 Sept 10
9/12
Specifications subject to change without notice
Route Départementale 128, BP46 - 91401 ORSAY Cedex - FRANCE
Tel.: +33 (0) 1 69 33 03 08 - Fax: +33 (0) 1 69 33 03 09
UMS [ UNITED MONOLITHIC SEMICONDUCTORS ]
