Preliminary
QPC7336
Electrical Specifications - continued
Parameter
Conditions (V+=5V, TMB=30°C, ZS=ZL=75)
Min
Typ
Max
Units
Control
Voltage Control Range, Positive
Attenuation Slope
5V control voltage is lowest slope, MODE pin high
0V control voltage is lowest slope, MODE pin low
0
0
5
V
V
Voltage Control Range, Negative
Attenuation Slope
5
MODE Pin Logic Low
MODE Pin Logic High
0.4
V
V
1
Notes:
1. Slope is defined as the difference between the gain at the start frequency and the gain at the stop frequency.
2. Flatness is defined as sum of positive and negative deviation from a straight line between gain at start frequency and gain at stop frequency.
3. Either Vc or Vc2 can be used to set slope, internal 1:4 voltage divider between Vc and Vc2
Data Sheet Rev.B, August 2, 2017 | Subject to change without notice
3 of 11
www.qorvo.com
TRIQUINT [ TRIQUINT SEMICONDUCTOR ]
