856879
782/751 MHz Duplexer
Specifications
Rx - Electrical Specifications
(1)
Specified Temperature Range:
(2)
-30 to +90 ºC
Parameter
(3)
Center Frequency
Maximum Insertion Loss
Amplitude/Passband Variation
(5)
Conditions
746 – 756 MHz
746 – 756 MHz
650 – 729 MHz
729 – 736 MHz
777 – 787 MHz
793 – 805 MHz
805 – 3200 MHz
3200 – 4200 MHz
4200 – 6000 MHz
746 – 756 MHz
746 – 756 MHz
746 – 756 MHz
746 – 756 MHz
Min
-
-
-
27
27
55
33
22
30
13
10
10
-5
-1.0
-
-
-
-
Typical
(4)
751
1.85
0.4
31
30
60
39
27
35
27
15
17
-
-
-110
-120
100
50
Max
-
2.5
1.1
-
-
-
-
-
-
-
-
-
+5
1.0
-106
-109
-
-
Units
MHz
dB
dB p-p
dB
dB
dB
dB
dB
dB
dB
dB
dB
degree
dB
dBm
dBm
Ω
Ω
Rejection/Attenuation
(6)
Return Loss at Rx
Return Loss at Antenna
Output Phase Balance
Output Amplitude Balance
IMR2
(7) (a,b)
IMR3
(7) (c,d)
Rx Impedance (balanced)
(8)
Antenna Impedance (single-ended)
(8)
Notes:
1. All specifications are based on the TriQuint schematic for the main reference design shown on page 7
2. In production, devices will be tested at room temperature to a guardbanded specification to ensure electrical compliance over temp
3. Electrical margin has been built into the design to account for the variations due to temperature drift and manufacturing tolerances
4. Typical values are based on average measurements at room temperature
5. Over a sliding 5 MHz window, in-band
6. Relative to zero dB
7. All power levels are referenced to the antenna port. Two CW tones are applied at frequencies f1 and f2, and the resultant
intermodulation product in the Rx band is measured. The first tone is applied to the Tx port, in the range f1 = 777 to 787 MHz, at
+21.5 dBm (referenced to the antenna port). The second tone is -15 dBm, applied to the antenna port at f2, with the following four
cases:
a. f2 = 31 MHz
b. f2 = 2 * f1 - 31 MHz
c. f2 = f1 + 31 MHz
d. f2 = 3 * f1 - 31 MHz
The intermodulation product is measured at f1 - 31 MHz.
8. This is the optimum impedance in order to achieve the performance shown
Data Sheet: Rev P 10/18/12
© 2012 TriQuint Semiconductor, Inc.
- 3 of 9 -
Disclaimer: Subject to change without notice
Connecting the Digital World to the Global Network