TMS320VC5416
Fixed-Point Digital Signal Processor
www.ti.com
SPRS095O–MARCH 1999–REVISED JANUARY 2005
15
8
IPTR
R/W-1FF
7
6
5
4
3
2
1
0
IPTR
MP/MC
OVLY
AVIS
DROM
CLKOFF
SMUL
SST
MP/MC pin
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
LEGEND: R = Read, W = Write, n = value present after reset
Figure 3-4. Process Mode Status Register
Table 3-2. Processor Mode Status (PMST) Register Bit Fields
BIT
NAME
RESET
VALUE
FUNCTION
NO.
Interrupt vector pointer. The 9-bit IPTR field points to the 128-word program page where the interrupt
vectors reside. The interrupt vectors can be remapped to RAM for boot-loaded operations. At reset,
these bits are all set to 1; the reset vector always resides at address FF80h in program memory space.
The RESET instruction does not affect this field.
15-7
IPTR
1FFh
Microprocessor/microcomputer mode. MP/MC enables/disables the on-chip ROM to be addressable in
program memory space.
•
•
MP/MC = 0: The on-chip ROM is enabled and addressable.
MP/MC = 1: The on-chip ROM is not available.
MP/MC
pin
6
5
MP/MC
MP/MC is set to the value corresponding to the logic level on the MP/MC pin when sampled at reset.
This pin is not sampled again until the next reset. The RESET instruction does not affect this bit. This
bit can also be set or cleared by software.
RAM overlay. OVLY enables on-chip dual-access data RAM blocks to be mapped into program space.
The values for the OVLY bit are:
OVLY
0
•
•
OVLY = 0: The on-chip RAM is addressable in data space but not in program space.
OVLY = 1: The on-chip RAM is mapped into program space and data space. Data page 0
(addresses 0h to 7Fh), however, is not mapped into program space.
Address visibility mode. AVIS enables/disables the internal program address to be visible at the
address pins.
•
AVIS = 0: The external address lines do not change with the internal program address. Control
and data lines are not affected and the address bus is driven with the last address on the bus.
4
3
AVIS
0
0
•
AVIS = 1: This mode allows the internal program address to appear at the pins of the device so
that the internal program address can be traced. Also, it allows the interrupt vector to be decoded
in conjunction with IACK when the interrupt vectors reside on on-chip memory.
DROM enables on-chip DARAM4-7 to be mapped into data space. The DROM bit values are:
DROM
•
•
DROM = 0: The on-chip DARAM4-7 is not mapped into data space.
DROM = 1: The on-chip DARAM4-7 is mapped into data space.
CLOCKOUT off. When the CLKOFF bit is 1, the output of CLKOUT is disabled and remains at a high
level.
2
1
0
CLKOFF
SMUL
SST
0
Saturation on multiplication. When SMUL = 1, saturation of a multiplication result occurs before
performing the accumulation in a MAC of MAS instruction. The SMUL bit applies only when OVM = 1
and FRCT = 1.
N/A
N/A
Saturation on store. When SST = 1, saturation of the data from the accumulator is enabled before
storing in memory. The saturation is performed after the shift operation.
22
Functional Overview
TI [ TEXAS INSTRUMENTS ]
