Revision History
REVISION HISTORY
This data sheet revision history highlights the technical changes made to the SPRS007C device-specific data
sheet to make it an SPRS007D revision.
Scope: This document has been reviewed for technical accuracy; the technical content is up-to-date as of the
specified release date with the following changes.
PAGE(S)
ADDITIONS/CHANGES/DELETIONS
NO.
21
Added “This pin must be tied directly to DV to enable HPI.” to the HPIENA description and “This pin must be tied directly to
DD
DV to enable HPI16 mode.” to the HPI16 description in Table 2−2. Also deleted “Internally pulled low.” from the HPI16
DD
description.
38
Added the following to Section 3.9: “Since the Timer1 output is multiplexed externally with the HINT output, the HPI must be
disabled (HPIENA input pin = 0) if the Timer1 output is to be used. The Timer1 output also has a dedicated enable bit in the
General Purpose I/O Control Register (GPIOCR) located at data memory address 003Ch. If the external Timer1 output is to
be used, in addition to disabling the HPI, the TOUT1 bit in the GPIOCR must also be set to 1.”
42
48
Changed the parenthetical statement “(such as the McBSPs)” in Section 3.12. to read “(such as the McBSPs, but not the
UART)”
Added the following footnote to Table 3−12: “Note that the UART DMA synchronization event is usable as a synchronization
event only, and is not usable for transferring data to or from the UART. The DMA cannot be used to transfer data to or from
the UART.”
59
60
Changed Figure 3−23, bit 15 from “Reserved” to “TOUT1”.
Added the following paragraph to Section 3.14.2: “Bit 15 of the GPIOCR is also used as the Timer1 output enable bit, TOUT1.
The TOUT1 bit enables or disables the Timer1 output on the HINT/TOUT1 pin. If TOUT1 = 0, the Timer1 output is not
available externally; if TOUT1 = 1, the Timer1 output is driven on the HINT/TOUT1 pin. Note also that the Timer1 output is
only available when the HPI is disabled (HPIENA input pin = 0).”
71
Changed the I
parameter from “60” to “42” in the Electrical Characteristics Over Recommended Operating Case
DDC
Temperature Range table.
3
November 2001 − Revised April 2004
SPRS007D
TI [ TEXAS INSTRUMENTS ]
