TL061, TL061A, TL061B, TL062, TL062A
TL062B, TL064, TL064A, TL064B
LOW POWER JFET INPUT OPERATIONAL AMPLIFIERS
SLOS078J − NOVEMBER 1978 − REVISED SEPTEMBER 2004
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
†
TL06_C
TL06_AC
TL06_BC
Supply voltage, VCC+ (see Note 1)
Supply voltage, VCC− (see Note 1)
Differential input voltage, VID (see Note 2)
Input voltage, VI (see Notes 1 and 3)
Duration of output short circuit (see Note 4)
D (8-pin) package
D (14-pin) package
N package
NS package
Package thermal impedance,
θ
JA (see Notes 5 and 6)
P package
PS package
PW (8-pin) package
PW (14-pin)
package
FK package
Package thermal impedance,
θ
JC (see Notes 7 and 8)
J package
JG package
W package
Operating virtual junction temperature, TJ
Case temperature for 60 seconds
Lead temperature 1,6 mm (1/16 inch) from case for 60
seconds
Lead temperature 1,6 mm (1/6 inch) from case for 10
seconds
Storage temperature range, Tstg
FK package
J, JG, U, or
W package
D, N, NS, P, PS,
or PW package
260
−65 to 150
260
−65 to 150
−65 to 150
150
150
18
−18
±30
±15
Unlimited
97
86
80
76
85
95
149
113
TL06_I
18
−18
±30
±15
Unlimited
97
86
80
76
85
95
149
113
5.61
15.05
14.5
14.65
150
260
300
°C
°C
°C
°C
°C
°C/W
°C/W
C/W
TL06_M
18
−18
±30
±15
Unlimited
UNIT
V
V
V
V
† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltage values except differential voltages are with respect to the midpoint between VCC+ and VCC−.
2. Differential voltages are at IN+ with respect to IN−.
3. The magnitude of the input voltage should never exceed the magnitude of the supply voltage or 15 V, whichever is less.
4. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be limited to ensure that the
dissipation rating is not exceeded.
5. Maximum power dissipation is a function of TJ(max),
θ
JA, and TA. The maximum allowable power dissipation at any allowable
ambient temperature is PD = (TJ(max) − TA)/θJA. Operating at the absolute maximum TJ of 150°C can affect reliability.
6. The package thermal impedance is calculated in accordance with JESD 51-7.
7. Maximum power dissipation is a function of TJ(max),
θ
JC, and TC. The maximum allowable power dissipation at any allowable case
temperature is PD = (TJ(max) − TC)/θJC. Operating at the absolute maximum TJ of 150°C can affect reliability.
8. The package thermal impedance is calculated in accordance with MIL-STD-883.
POST OFFICE BOX 655303
•
DALLAS, TEXAS 75265
5
TI [ TEXAS INSTRUMENTS ]
