PACKAGE/ORDERING INFORMATION(1)
PACKAGE
DRAWING
DESIGNATOR
PACKAGE
MARKING
PRODUCT
PACKAGE-LEAD
Single
OPA336N
OPA336NA
OPA336NJ
OPA336U
OPA336UA
OPA336UJ
SOT23-5
SOT23-5
SOT23-5
DBV
DBV
DBV
D
D
D
A36(2)
A36(2)
J36
OPA336U
OPA336UA
OPA336UJ
SO-8 Surface-Mount
SO-8 Surface-Mount
SO-8 Surface-Mount
Dual
OPA2336E
OPA2336EA
OPA2336P
MSOP-8 Surface-Mount
MSOP-8 Surface-Mount
DIP-8
DGK
DGK
P
B36(2)
B36(2)
OPA2336P
OPA2336PA
DIP-8
P
OPA2336PA
OPA2336U
OPA2336UA
SO-8 Surface-Mount
SO-8 Surface-Mount
D
D
OPA2336U
OPA2336UA
Quad
OPA4336EA
SSOP-16 Surface-Mount
DBQ
OPA4336EA
NOTES: (1) For the most current package and ordering information, see the package option addendum at the end of this data sheet. (2) Grade will be marked on
the Reel.
ABSOLUTE MAXIMUM RATINGS(1)
ELECTROSTATIC
Supply Voltage ................................................................................... 7.5V
DISCHARGE SENSITIVITY
Signal Input Terminals, Voltage(2) .....................(V–) –0.3V to (V+) +0.3V
Current(2) .................................................... 10mA
This integrated circuit can be damaged by ESD. Texas
Instruments recommends that all integrated circuits be handled
with appropriate precautions. Failure to observe proper han-
dling and installation procedures can cause damage.
Output Short-Circuit(3) .............................................................. Continuous
Operating Temperature ..................................................–55°C to +125°C
Storage Temperature .....................................................–55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s)................................................. 300°C
ESD Rating:
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
Charged Device Model, OPA336 NJ and UJ only (CDM)(4) ....... 1000V
Human Body Model (HBM)(4) ......................................................... 500V
Machine Model (MM)(4) .................................................................. 100V
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only. Functional opera-
tion of the device at these conditions, or beyond the specified operating
conditions, is not implied. (2) Input terminals are diode-clamped to the power
supply rails. Input signals that can swing more than 0.3V beyond the supply
rails should be current-limited to 10mA or less. (3) Short-circuit to ground,
one amplifier per package. (4) OPA336 NJ and UJ have been tested to CDM
of 1000V. All other previous package versions have been tested using HBM
and MM. Results are shown.
OPA336, 2336, 4336
2
SBOS068C
www.ti.com
TI [ TEXAS INSTRUMENTS ]
