LM1577, LM2577
www.ti.com
SNOS658D –JUNE 1999–REVISED APRIL 2013
Table 5. Flyback Regulator Formulas (continued)
Peak Primary Current
IP(PK)
(19)
(20)
Switch Voltage when Off
VSW(OFF)
−
Diode Reverse Voltage
Average Diode Current
Peak Diode Current
VR
VOUT+ N (VIN VSAT
)
ID(AVE)
ILOAD
ID(PK)
(21)
(22)
Short Circuit Diode Current
Power Dissipation of LM1577/LM2577
PD
(23)
C. Calculate the minimum value of CC
(24)
(25)
D. Calculate the maximum ESR of the +VOUT and −VOUT output capacitors in parallel.
This formula can also be used to calculate the maximum ESR of a single output regulator.
At this point, refer to this same section in the STEP-UP REGULATOR DESIGN PROCEDURE section for more
information regarding the selection of COUT
.
3. Output Voltage Selection
This section is for applications using the LM1577-ADJ/LM2577-ADJ. Skip this section if the LM1577-12/LM2577-
12 or LM1577-15/LM2577-15 is being used.
With the LM1577-ADJ/LM2577-ADJ, the output voltage is given by
VOUT = 1.23V (1 + R1/R2)
(26)
Resistors R1 and R2 divide the output voltage down so it can be compared with the LM1577-ADJ/LM2577-ADJ
internal 1.23V reference. For a desired output voltage VOUT, select R1 and R2 so that
(27)
4. Diode Selection
The switching diode in a flyback converter must withstand the reverse voltage specified by the following
equation.
(28)
A suitable diode must have a reverse voltage rating greater than this. In addition it must be rated for more than
the average and peak diode currents listed in Table 5.
5. Input Capacitor Selection
Copyright © 1999–2013, Texas Instruments Incorporated
Submit Documentation Feedback
25
Product Folder Links: LM1577 LM2577
TI [ TEXAS INSTRUMENTS ]
