78P2343JAT
3-port E3/DS3/STS-1 LIU
with Jitter Attenuator
ELECTRICAL SPECIFICATIONS (continued)
DS3/STS-1 -- RECEIVER SPECIFICATIONS (Transformer-coupled)
PARAMETER
CONDITION
MIN
TYP
MAX
UNIT
MON=0;
Signal at DSX is 360-850 mVpk.
(see Note 2)
90
850
mVpk
Peak Differential Input
Amplitude, LINPx and LINNx
(see Note 1)
MON=1
(see Note 3)
25
90
0
80
1200
6
mVpk
mVpk
dB
MON=0; DS3-HIGH
(see Note 4)
MON=0.
Flat-loss Tolerance
Receive Clock Jitter
All valid cable lengths.
DS3 mode with 10 Hz – 400 kHz
a) Normal receive mode
b) Remote loopback mode
0.1
0.06
UIpp
UIpp
Interfering Tone Tolerance
(see Note 5)
Maximum ratio of Interference Power
to Signal Power for BER < 10-8
a) With 0ft cable from DSX
-9
-10
dB
dB
b) With 450ft cable from DSX
Note 1: Signal source should meet DS3 template of ANSI-T102.1993 Figure 4 and STS-1 template of ANSI-
T102.1993 Figure 5. Loss characteristics of the WE728A or RG59B cable should be better than Figure
C2 of ANSI-T102.1993.
Note 2: Min spec corresponds to minimum DSX amplitude, 5.5dB of cable loss (450ft) and 6dB of flat
attenuation. Error-free receiver performance is guaranteed for up to 600ft of cable from DSX cross-
connect. Typical part can handle up to 900ft.
Note 3: Min spec corresponds to amplitude of 425mVpk at DSX, 5.5dB of cable loss (450ft) and 20dB of flat
attenuation. In monitor mode, interfering tone performance is not guaranteed.
Note 4: In this mode, no noise, jitter, or interfering tone impairments should be added for guaranteed receiver
performance.
Note 5: Interfering signal is a non-synchronous sinusoidal tone of 22.368MHz for DS3 or 25.92MHz for STS-1.
Data is a PRBS15 (215-1) pattern.
Page 29 of 37
2005 Teridian Semiconductor Corporation
Rev 2.2
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
