欢迎访问ic37.com |
会员登录 免费注册
发布采购

CC2430EMK 参数 Datasheet PDF下载

CC2430EMK图片预览
型号: CC2430EMK
PDF下载: 下载PDF文件 查看货源
内容描述: 真正的系统级芯片解决方案的2.4 GHz IEEE 802.15.4 / ZigBee的 [A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee]
分类和应用:
文件页数/大小: 212 页 / 1862 K
品牌: TAOS [ TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS ]
 浏览型号CC2430EMK的Datasheet PDF文件第10页浏览型号CC2430EMK的Datasheet PDF文件第11页浏览型号CC2430EMK的Datasheet PDF文件第12页浏览型号CC2430EMK的Datasheet PDF文件第13页浏览型号CC2430EMK的Datasheet PDF文件第15页浏览型号CC2430EMK的Datasheet PDF文件第16页浏览型号CC2430EMK的Datasheet PDF文件第17页浏览型号CC2430EMK的Datasheet PDF文件第18页  
CC2430  
Table 7: RF Transmit Parameters  
Parameter  
Min  
Typ  
Max Unit Condition/Note  
Nominal output  
power  
0
dBm  
Delivered to a single ended 50 load through a balun and  
output power control set to 0x5F (TXCTRLL).  
[1] requires minimum –3 dBm  
Programmable  
output power range  
26  
dB  
The output power is programmable in 16 steps from typically  
-25.2 to 0.6 dBm (see Table 45).  
Harmonics  
2nd harmonic  
3rd harmonic  
4th harmonic  
5th harmonic  
-50.7  
-55.8  
-54.2  
-53.4  
dBm Measurement conducted with 100 kHz resolution bandwidth on  
spectrum analyzer and output power control set to 0x5F  
(TXCTRLL). Output Delivered to a single ended 50 load  
through a balun.  
dBm  
dBm  
dBm  
Maximum output power.  
Texas Instruments CC2430 EM reference design complies with  
EN 300 328, EN 300 440, FCC CFR47 Part 15 and ARIB STD-  
Spurious emission  
30 - 1000 MHz  
1– 12.75 GHz  
1.8 – 1.9 GHz  
5.15 – 5.3 GHz  
-47  
-43  
-58  
-56  
dBm  
dBm  
T-66.  
Transmit on 2480MHz under FCC is supported by duty-cycling,  
or by reducing output power  
dBm  
dBm  
The peak conducted spurious emission is -47 dBm @ 192 MHz  
which is in an EN 300 440 restricted band limited to -54 dBm. All  
radiated spurious emissions are within the limits of  
ETSI/FCC/ARIB. Conducted spurious emission (CSE) can be  
reduced with a simple band pass filter connected between  
matching network and RF connector (1.8 pF in parallel with 1.6  
nH reduces the CSE by 20 dB), this filter must be connected to  
good RF ground.  
Error Vector  
Magnitude (EVM)  
11  
%
Measured as defined by [1]  
[1] requires max. 35 %  
Optimum load  
impedance  
60  
+ j164  
Differential impedance as seen from the RF-port (RF_Pand  
RF_N) towards the antenna2.  
7.4 32 MHz Crystal Oscillator  
Measured on Texas Instruments CC2430 EM reference design with TA=25°C and VDD=3.0V  
unless stated otherwise.  
Table 8: 32 MHz Crystal Oscillator Parameters  
Parameter  
Min  
Typ  
Max  
Unit  
MHz  
ppm  
Condition/Note  
Crystal frequency  
32  
Crystal frequency  
accuracy  
- 40  
40  
Including aging and temperature dependency, as specified by [1]  
requirement  
ESR  
6
1
16  
1.9  
13  
60  
7
Simulated over operating conditions  
Simulated over operating conditions  
Simulated over operating conditions  
pF  
pF  
µs  
C0  
CL  
10  
16  
Start-up time  
212  
7.5 32.768 kHz Crystal Oscillator  
Measured on Texas Instruments CC2430 EM reference design with TA=25°C and VDD=3.0V  
unless stated otherwise.  
2 This is for 2440MHz  
CC2430 Data Sheet (rev. 2.1) SWRS036F  
Page 14 of 211