SMS47
PreliminaryInformation
PIN DESCRIPTIONS (CONTINUED)
A1,A2 (6, 7)
A1 and A2 are the address inputs. When addressing the
SMS47 configuration registers the address inputs distin-
guish which one of four possible devices sharing the
common bus is being addressed.
SDA(9)
SDA is the serial data input/output pin. It should be tied to
VDD_CAP through a pull-up resistor.
SCL(10)
SCListheserialclockinput. ItshouldbetiedtoVDD_CAP
through a pull-up resistor.
PUP#1, PUP#2, PUP#3 (4, 5, 13)
These are the power-up permitted (PUP) active low open
drain outputs. The PUP pins are used when the SMS47 is
programmed to provide the cascade sequencing of LDOs
or DC/DC converters (see Figures 1 and 5 for illustra-
tionsofcascading). Eachdelayisindependentlyenabled
andprogrammableforitsduration(configurationregister
7). If all PUP# outputs are enabled the order of events
would be as follows: V0 above threshold then delay to
PUP#1turningon;V1abovethresholdthendelaytoPUP#2
turningon;V2abovethresholdthendelaytoPUP#3turning
on. The delays are programmable.
SUMMIT MICROELECTRONICS, Inc.
2087 1.0 04/11/05
7
SUMMIT [ SUMMIT MICROELECTRONICS, INC. ]
