STM8S207xx, STM8S208xx
Electrical characteristics
Table 16. Current characteristics
Symbol
Ratings
Max.(1)
Unit
IVDD
IVSS
Total current into VDD power lines (source)(2)
Total current out of VSS ground lines (sink)(2)
Output current sunk by any I/O and control pin
Output current source by any I/Os and control pin
60
60
20
20
IIO
Total output current sourced (sum of all I/O and control pins)
for devices with two VDDIO pins(3)
200
100
160
80
Total output current sourced (sum of all I/O and control pins)
for devices with one VDDIO pin(3)
ΣIIO
mA
Total output current sunk (sum of all I/O and control pins) for
devices with two VSSIO pins(3)
Total output current sunk (sum of all I/O and control pins) for
devices with one VSSIO pin(3)
Injected current on NRST pin
4
4
(4)(5)
IINJ(PIN)
Injected current on OSCIN pin
Injected current on any other pin(6)
Total injected current (sum of all I/O and control pins)(6)
4
(4)
ΣIINJ(PIN)
20
1. Data based on characterization results, not tested in production.
2. All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the
external supply.
3. I/O pins used simultaneously for high current source/sink must be uniformly spaced around the package
between the VDDIO/VSSIO pins.
4. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum
cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive
injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,
there is no positive injection current, and the corresponding VIN maximum must always be respected
5. Negative injection disturbs the analog performance of the device. See note in Section 10.3.10: 10-bit ADC
characteristics on page 83.
6. When several inputs are submitted to a current injection, the maximum ΣIINJ(PIN) is the absolute sum of the
positive and negative injected currents (instantaneous values). These results are based on
characterization with ΣIINJ(PIN) maximum current injection on four I/O port pins of the device.
Table 17. Thermal characteristics
Symbol
Ratings
Value
Unit
TSTG
TJ
Storage temperature range
-65 to 150
150
°C
Maximum junction temperature
Doc ID 14733 Rev 9
55/103