STM32F103x4, STM32F103x6
Electrical characteristics
Output driving current
The GPIOs (general purpose input/outputs) can sink or source up to +/-8 mA, and sink
+20 mA (with a relaxed V ).
OL
In the user application, the number of I/O pins which can drive current must be limited to
respect the absolute maximum rating specified in Section 5.2:
●
The sum of the currents sourced by all the I/Os on V
plus the maximum Run
DD,
consumption of the MCU sourced on V
cannot exceed the absolute maximum rating
DD,
I
(see Table 7).
VDD
●
The sum of the currents sunk by all the I/Os on V plus the maximum Run
SS
consumption of the MCU sunk on V cannot exceed the absolute maximum rating
SS
I
(see Table 7).
VSS
Output voltage levels
Unless otherwise specified, the parameters given in Table 35 are derived from tests
performed under ambient temperature and V supply voltage conditions summarized in
DD
Table 9. All I/Os are CMOS and TTL compliant.
Table 35. Output voltage characteristics
Symbol
Parameter
Conditions
Min
Max
Unit
Output low level voltage for an I/O pin
when 8 pins are sunk at same time
(1)
VOL
0.4
TTL port
IIO = +8 mA
V
Output high level voltage for an I/O pin
when 8 pins are sourced at same time
(2)
2.7 V < VDD < 3.6 V
VOH
VDD–0.4
Output low level voltage for an I/O pin
when 8 pins are sunk at same time
(1)
VOL
0.4
1.3
0.4
CMOS port
IIO =+ 8mA
V
V
V
Output high level voltage for an I/O pin
when 8 pins are sourced at same time
(2)
2.7 V < VDD < 3.6 V
VOH
2.4
Output low level voltage for an I/O pin
when 8 pins are sunk at same time
(1)(3)
VOL
IIO = +20 mA
2.7 V < VDD < 3.6 V
Output high level voltage for an I/O pin
when 8 pins are sourced at same time
(2)(3)
VOH
VDD–1.3
VDD–0.4
Output low level voltage for an I/O pin
when 8 pins are sunk at same time
(1)(3)
VOL
IIO = +6 mA
2 V < VDD < 2.7 V
Output high level voltage for an I/O pin
when 8 pins are sourced at same time
(2)(3)
VOH
1. The IIO current sunk by the device must always respect the absolute maximum rating specified in Table 7
and the sum of IIO (I/O ports and control pins) must not exceed IVSS
.
2. The IIO current sourced by the device must always respect the absolute maximum rating specified in
Table 7 and the sum of IIO (I/O ports and control pins) must not exceed IVDD
.
3. Based on characterization data, not tested in production.
Doc ID 15060 Rev 3
53/80
STMICROELECTRONICS [ ST ]
