Electrical characteristics
STM32F103xC, STM32F103xD, STM32F103xE
Figure 21. Low-speed external clock source AC timing diagram
V
LSEH
90%
10%
V
LSEL
t
t
t
W(LSE)
t
t
W(LSE)
r(LSE)
f(LSE)
T
LSE
f
LSE_ext
EXTERNAL
CLOCK SOURCE
I
L
OSC32_IN
STM32F103xx
ai14144b
High-speed external clock generated from a crystal/ceramic resonator
The high-speed external (HSE) clock can be supplied with a 4 to 16 MHz crystal/ceramic
resonator oscillator. All the information given in this paragraph are based on characterization
results obtained with typical external components specified in Table 23. In the application,
the resonator and the load capacitors have to be placed as close as possible to the oscillator
pins in order to minimize output distortion and startup stabilization time. Refer to the crystal
resonator manufacturer for more details on the resonator characteristics (frequency,
package, accuracy).
(1)(2)
Table 23. HSE 4-16 MHz oscillator characteristics
Symbol
Parameter
Conditions
Min
Typ Max Unit
fOSC_IN Oscillator frequency
4
8
16
MHz
RF
C
Feedback resistor
200
k
Recommended load capacitance
versus equivalent serial
RS = 30
30
pF
resistance of the crystal (RS)(3)
VDD= 3.3 V, VIN = VSS
with 30 pF load
i2
HSE driving current
1
mA
gm
Oscillator transconductance
Startup time
Startup
25
mA/V
ms
(4)
tSU(HSE)
VDD is stabilized
2
1. Resonator characteristics given by the crystal/ceramic resonator manufacturer.
2. Based on characterization results, not tested in production.
3. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a
humid environment, due to the induced leakage and the bias condition change. However, it is
recommended to take this point into account if the MCU is used in tough humidity conditions.
4. tSU(HSE) is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz
oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly
with the crystal manufacturer
For C and C , it is recommended to use high-quality external ceramic capacitors in the
L1
L2
5 pF to 25 pF range (typ.), designed for high-frequency applications, and selected to match
the requirements of the crystal or resonator (see Figure 22). C and C are usually the
L1
L2
56/123
Doc ID 14611 Rev 7