Electrical characteristics
STM32F103xC, STM32F103xD, STM32F103xE
Figure 21. Low-speed external clock source AC timing diagram
VLSEH
90%
VLSEL
10%
tr(LSE)
TLSE
tf(LSE)
tW(LSE)
tW(LSE)
t
EXTER NAL
CLOCK SOURC E
fLSE_ext
OSC32_IN
IL
STM32F103xx
ai14144b
High-speed external clock generated from a crystal/ceramic resonator
The high-speed external (HSE) clock can be supplied with a 4 to 16 MHz crystal/ceramic
resonator oscillator. All the information given in this paragraph are based on characterization
results obtained with typical external components specified in
In the application,
the resonator and the load capacitors have to be placed as close as possible to the oscillator
pins in order to minimize output distortion and startup stabilization time. Refer to the crystal
resonator manufacturer for more details on the resonator characteristics (frequency,
package, accuracy).
Table 23.
Symbol
f
OSC_IN
R
F
C
HSE 4-16 MHz oscillator characteristics
(1)(2)
Parameter
Oscillator frequency
Feedback resistor
Recommended load capacitance
versus equivalent serial
resistance of the crystal (R
S
)
(3)
HSE driving current
Oscillator transconductance
R
S
= 30
V
DD
= 3.3 V, V
IN
= V
SS
with 30 pF load
Startup
V
DD
is stabilized
25
2
Conditions
Min
4
Typ
8
200
30
Max
16
Unit
MHz
k
pF
i
2
g
m
1
mA
mA/V
ms
t
SU(HSE)(4)
Startup time
1. Resonator characteristics given by the crystal/ceramic resonator manufacturer.
2. Based on characterization results, not tested in production.
3. The relatively low value of the RF resistor offers a good protection against issues resulting from use in a
humid environment, due to the induced leakage and the bias condition change. However, it is
recommended to take this point into account if the MCU is used in tough humidity conditions.
4. t
SU(HSE)
is the startup time measured from the moment it is enabled (by software) to a stabilized 8 MHz
oscillation is reached. This value is measured for a standard crystal resonator and it can vary significantly
with the crystal manufacturer
For C
L1
and C
L2
, it is recommended to use high-quality external ceramic capacitors in the
5 pF to 25 pF range (typ.), designed for high-frequency applications, and selected to match
the requirements of the crystal or resonator (see
C
L1
and C
L2
are usually the
56/123
Doc ID 14611 Rev 7
STMICROELECTRONICS [ STMICROELECTRONICS ]
