STM32F103xC, STM32F103xD, STM32F103xE
I2S - SPI characteristics
Electrical characteristics
2
Unless otherwise specified, the parameters given in Table 53 for SPI or in Table 54 for I S
are derived from tests performed under ambient temperature, f
frequency and V
PCLKx
DD
supply voltage conditions summarized in Table 10.
Refer to Section 5.3.14: I/O port characteristics for more details on the input/output alternate
2
function characteristics (NSS, SCK, MOSI, MISO for SPI and WS, CK, SD for I S).
Table 53. SPI characteristics
Symbol
Parameter
Conditions
Master mode
Min
Max
Unit
18
18
fSCK
1/tc(SCK)
SPI clock frequency
MHz
Slave mode
tr(SCK)
tf(SCK)
SPI clock rise and fall
time
Capacitive load: C = 30 pF
8
ns
%
SPI slave input clock duty
cycle
DuCy(SCK)
Slave mode
30
70
(1)
tsu(NSS)
NSS setup time
NSS hold time
Slave mode
Slave mode
4tPCLK
2tPCLK
(1)
th(NSS)
(1)
tw(SCKH)
tw(SCKL)
Master mode, fPCLK = 36 MHz,
presc = 4
SCK high and low time
Data input setup time
50
60
(1)
(1)
Master mode
Slave mode
Master mode
Slave mode
5
5
5
4
0
2
tsu(MI)
tsu(SI)
(1)
(1)
th(MI)
Data input hold time
ns
(1)
th(SI)
(1)(2)
ta(SO)
Data output access time Slave mode, fPCLK = 20 MHz
Data output disable time Slave mode
3tPCLK
10
(1)(3)
tdis(SO)
(1)
tv(SO)
Data output valid time
Data output valid time
Slave mode (after enable edge)
Master mode (after enable edge)
Slave mode (after enable edge)
Master mode (after enable edge)
25
(1)
tv(MO)
5
(1)
th(SO)
15
2
Data output hold time
(1)
th(MO)
1. Based on characterization, not tested in production.
2. Min time is for the minimum time to drive the output and the max time is for the maximum time to validate
the data.
3. Min time is for the minimum time to invalidate the output and the max time is for the maximum time to put
the data in Hi-Z
Doc ID 14611 Rev 8
95/130
STMICROELECTRONICS [ ST ]
