M27C4002
Table 5. AC Measurement Conditions
High Speed
Input Rise and Fall Times
Input Pulse Voltages
Input and Output Timing Ref. Voltages
≤
10ns
0 to 3V
1.5V
Standard
≤
20ns
0.4V to 2.4V
0.8V and 2V
Figure 3. AC Testing Input Output Waveform
Figure 4. AC Testing Load Circuit
1.3V
High Speed
3V
1.5V
0V
DEVICE
UNDER
TEST
2.0V
0.8V
AI01822
1N914
3.3kΩ
Standard
2.4V
OUT
CL
0.4V
CL = 30pF for High Speed
CL = 100pF for Standard
CL includes JIG capacitance
AI01823B
Table 6. Capacitance
(1)
(T
A
= 25
°C,
f = 1 MHz )
Symbol
C
IN
C
OUT
Parameter
Input Capacitance
Output Capacitance
Test Condition
V
IN
= 0V
V
OUT
= 0V
Min
Max
6
12
Unit
pF
pF
Note:
1. Sampled only, not 100% tested.
System Considerations
The power switching characteristics of Advanced
CMOS EPROMs require careful decoupling of the
devices. The supply current, I
CC
, has three seg-
ments that are of interest to the system designer:
the standby current level, the active current level,
and transient current peaks that are produced by
the falling and rising edges of E. The magnitude of
the transient current peaks is dependent on the
output capacitive and inductive loading of the de-
vice.
The associated transient voltage peaks can be
suppressed by complying with the two line output
control and by properly selected decoupling ca-
pacitors. It is recommended that a 0.1µF ceramic
capacitor be used on every device between V
CC
and V
SS
. This should be a high frequency capacitor
of low inherent inductance and should be placed
as close to the device as possible. In addition, a
4.7µF bulk electrolytic capacitor should be used
between V
CC
and V
SS
for every eight devices. The
bulk capacitor should be located near the power
supply connection point.The purpose of the bulk
capacitor is to overcome the voltage drop caused
by the inductive effects of PCB traces.
4/16
STMICROELECTRONICS [ STMICROELECTRONICS ]
