Absolute maximum ratings and operating conditions
LMV321, LMV358, LMV324
1
Absolute maximum ratings and operating conditions
Table 1.
Symbol
V
CC
V
id
V
in
T
oper
T
stg
T
j
Supply voltage
(1)
Differential input voltage
(2)
Input voltage
Operating free air temperature range
Storage temperature
Maximum junction temperature
Thermal resistance junction to ambient
(3)
SOT23-5
SO-8
SO-14
TSSOP8
TSSOP14
Thermal resistance junction to case
(3)
SOT23-5
SO-8
SO-14
TSSOP8
TSSOP14
HBM: human body model
(4)
ESD
MM: machine model
(5)
CDM: charged device model
(6)
Lead temperature (soldering, 10sec)
Output short-circuit duration
Absolute maximum ratings
Parameter
Value
7
±1
V
DD
-0.3 to V
CC
+0.3
-40 to + 125
-65 to +150
150
250
125
103
120
100
81
40
31
37
32
2
200
1.5
250
see note
(7)
Unit
V
V
V
°C
°C
°C
R
thja
°C/W
R
thjc
°C/W
kV
V
kV
°C
1. All voltage values, except differential voltage are with respect to network terminal.
2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. If
V
id
> ±1 V, the maximum input current must not exceed ±1 mA. In this case (V
id
> ±1 V), an input series
resistor must be added to limit input current.
3. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-
circuits on all amplifiers. All values are typical.
4. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 k
Ω
resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
5. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5
Ω
). This is done for all couples of
connected pin combinations while the other pins are floating.
6. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
No value specified for CDM on SOT23-5L package. The value is given for SO and TSSOP packages.
7. Short-circuits from the output to V
CC
can cause excessive heating. The maximum output current is
approximately 48 mA, independent of the magnitude of V
CC
. Destructive dissipation can result from
simultaneous short-circuits on all amplifiers.
2/16
Doc ID 11887 Rev 4
STMICROELECTRONICS [ STMICROELECTRONICS ]
