LM158-LM258-LM358-LM158A-LM258A-LM358A
Absolute Maximum Ratings
1
Absolute Maximum Ratings
Table 1.
Symbol
Key parameters and their absolute maximum ratings
Parameter
LM158,A
LM258,A
LM358,A Unit
V
Supply voltage
Input Voltage
+/-16 or 32
-0.3 to +32
+32
V
V
CC
Vi
V
Differential Input Voltage
V
id
(1)
P
500
mW
Power Dissipation
tot
(2)
Infinite
50
Output Short-circuit Duration
(3)
I
mA
Input Current
in
T
Operating Free-air Temperature Range
Storage Temperature Range
-55 to +125 -40 to +105 0 to +70
°C
°C
°C
oper
T
-65 to +150
150
stg
T
Maximum Junction Temperature
j
(4)
R
Thermal Resistance Junction to Ambient
thja
SO8
TSSOP8
DIP8
125
120
85
°C/W
190
miniSO8
(5)
300
V
HBM: Human Body Model
(6)
ESD
200
1.5
V
MM: Machine Model
CDM: Charged Device Model
kV
1. Power dissipation must be considered to ensure maximum junction temperature (Tj) is not exceeded.
2. Short-circuits from the output to VCC can cause excessive heating if VCC > 15V. The maximum output current
is approximately 40mA independent
of the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuit on all amplifiers.
3. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP
transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this diode action,
there is also NPN parasitic action on
the IC chip. this transistor action can cause the output voltages of the Op-amps to go to the VCC voltage level
(or to ground for a large overdrive)
for the time duration than an input is driven negative.
This is not destructive and normal output will set up again for input voltage higher than -0.3V.
4. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuit
on all amplifiers
5. Human body model, 100pF discharged through a 1.5kΩ resistor into pin of device.
6. Machine model ESD, a 200pF cap is charged to the specified voltage, then discharged directly into the IC with
no external series resistor (internal resistor < 5Ω), into pin to pin of device.
3/16
STMICROELECTRONICS [ ST ]
