欢迎访问ic37.com |
会员登录 免费注册
发布采购

L6562AT 参数 Datasheet PDF下载

L6562AT图片预览
型号: L6562AT
PDF下载: 下载PDF文件 查看货源
内容描述: 转换模式PFC控制器 [Transition-mode PFC controller]
分类和应用: 功率因数校正控制器
文件页数/大小: 25 页 / 491 K
品牌: STMICROELECTRONICS [ ST ]
 浏览型号L6562AT的Datasheet PDF文件第9页浏览型号L6562AT的Datasheet PDF文件第10页浏览型号L6562AT的Datasheet PDF文件第11页浏览型号L6562AT的Datasheet PDF文件第12页浏览型号L6562AT的Datasheet PDF文件第14页浏览型号L6562AT的Datasheet PDF文件第15页浏览型号L6562AT的Datasheet PDF文件第16页浏览型号L6562AT的Datasheet PDF文件第17页  
Application information  
L6562AT  
When the load of a PFC pre-regulator is very low, the output voltage tends to stay steadily  
above the nominal value, which cannot be handled by the Dynamic OVP. If this occurs,  
however, the error amplifier output will saturate low; hence, when this is detected the  
external power transistor is switched off and the IC put in an idle state (static OVP). Normal  
operation is resumed as the error amplifier goes back into its linear region. As a result, the  
device will work in burst-mode, with a repetition rate that can be very low.  
When either OVP is activated the quiescent consumption of the IC is reduced to minimize  
the discharge of the Vcc capacitor and increase the hold-up capability of the IC supply  
system.  
7.2  
7.3  
Disable function  
The INV pin doubles its function as a not-latched IC disable: a voltage below 0.2 V shuts  
down the IC and reduces its consumption at a lower value. To restart the IC, the voltage on  
the pin must exceed 0.45 V. The main usage of this function is a remote ON/OFF control  
input that can be driven by a PWM controller for power management purposes. However it  
also offers a certain degree of additional safety since it will cause the IC to shutdown in case  
the lower resistor of the output divider is shorted to ground or if the upper resistor is missing  
or fails open.  
THD optimizer circuit  
The device is equipped with a special circuit that reduces the conduction dead-angle  
occurring to the AC input current near the zero-crossings of the line voltage (crossover  
distortion). In this way the THD (total harmonic distortion) of the current is considerably  
reduced.  
A major cause of this distortion is the inability of the system to transfer energy effectively  
when the instantaneous line voltage is very low. This effect is magnified by the high-  
frequency filter capacitor placed after the bridge rectifier, which retains some residual  
voltage that causes the diodes of the bridge rectifier to be reverse-biased and the input  
current flow to temporarily stop.  
13/25