8 Mbit SPI Serial Flash
SST25LF080A
EOL Product Data Sheet
PRODUCT IDENTIFICATION
TABLE 2: P
RODUCT
I
DENTIFICATION
Address
Manufacturer’s ID
Device ID
SST25LF080A
00001H
80H
T2.0 1248
DEVICE OPERATION
The SST25LF080A is accessed through the SPI (Serial
Peripheral Interface) bus compatible protocol. The SPI bus
consist of four control lines; Chip Enable (CE#) is used to
select the device, and data is accessed through the Serial
Data Input (SI), Serial Data Output (SO), and Serial Clock
(SCK).
The SST25LF080A supports both Mode 0 (0,0) and Mode
3 (1,1) of SPI bus operations. The difference between the
two modes, as shown in Figure 2, is the state of the SCK
signal when the bus master is in Stand-by mode and no
data is being transferred. The SCK signal is low for Mode 0
and SCK signal is high for Mode 3. For both modes, the
Serial Data In (SI) is sampled at the rising edge of the SCK
clock signal and the Serial Data Output (SO) is driven after
the falling edge of the SCK clock signal.
Data
BFH
00000H
MEMORY ORGANIZATION
The SST25LF080A SuperFlash memory array is orga-
nized in 4 KByte sectors with 32 KByte overlay blocks.
CE#
MODE 3
MODE 3
MODE 0
SCK
SI
SO
MODE 0
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
MSB
DON'T CARE
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
MSB
1248 F02.0
HIGH IMPEDANCE
FIGURE 2: SPI P
ROTOCOL
©2006 Silicon Storage Technology, Inc.
S71248-06-EOL
1/06
4
SST [ SILICON STORAGE TECHNOLOGY, INC ]
