2.4-2.5 GHz Power Amplifier
SST12LP00
Preliminary Specifications
ELECTRICAL SPECIFICATIONS
The AC and DC specifications for the power amplifier interface signals. Refer to Table 2 for the DC voltage and current spec-
ifications. Refer to Figure 3 for the RF performance.
Absolute Maximum Stress Ratings (Applied conditions greater than those listed under “Absolute Maximum
Stress Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation
of the device at these conditions or conditions greater than those defined in the operational sections of this data
sheet is not implied. Exposure to absolute maximum stress rating conditions may affect device reliability.)
Supply Voltage at pins 4, 5, and 6 (VCC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +3.6V
Power-down Control Voltage (PDC). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC
Gain Control Voltage (GCTL). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC
Radio Frequency Input Power (RFIN). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +10 dBm
Operating Temperature (TA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +85ºC
Storage Temperature (TSTG) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +120ºC
Maximum Junction Temperature (TJ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +150ºC
Surface Mount Solder Reflow Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C for 10 seconds
Operating Range
Range
Ambient Temp
VCC
Industrial
-40°C to +85°C
3.3V
TABLE 2: DC Electrical Characteristics
Symbol
VCC
Parameter
Supply Voltage at pins 4, 5, and 6
Supply Current @ POUT = 23 dBm
Power Amplifier Gain Control Voltage
Current through GCTL pin
Min. Typ Max. Unit Test Conditions
2.7
0.1
2.6
3.3
115
3.0
55
3.6
V
mA
V
ICC
GCTL
IGCTL
PDC
3.3
100
µA
V
Logic High Voltage
Logic Low Voltage
0.8
V
ICQ
Idle Current (GCTL = 3.0V)
10
mA
T2.3 1283
TABLE 3: AC Electrical Characteristics
Symbol
FL-U
Parameter
Min.
2402
Typ
Max.
Unit
Frequency range
2480
MHz
POUT
Output power
@ PIN = -7 dBm, VCC = 3.3V, GCTL = 3.0V
Small signal gain
23
27
dBm
dB
G
GVAR
Gain variation over band (2400~2485 MHz)
0.2
0.5
dB
T3.2 1283
©2006 SST Communications Corp.
S71283-01-000
3/06
3
SST [ SILICON STORAGE TECHNOLOGY, INC ]
