2.4-2.5 GHz Low-Noise Amplifier
SST12LN01
Preliminary Specifications
ELECTRICAL SPECIFICATIONS
The AC and DC specifications for the power amplifier interface signals. Refer to Table 2 for the DC voltage and current spec-
ifications. Refer to Figure 3 for the RF performance.
Absolute Maximum Stress Ratings (Applied conditions greater than those listed under “Absolute Maximum
Stress Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation
of the device at these conditions or conditions greater than those defined in the operational sections of this data
sheet is not implied. Exposure to absolute maximum stress rating conditions may affect device reliability.)
Input power to pin 2 (PIN). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +5 dBm
Average output power (POUT)1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-15 dBm
Supply Voltage at pin 6 (VDD). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +3.5V
DC supply current (ICC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 mA
Operating Temperature (TA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +85ºC
Storage Temperature (TSTG) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40ºC to +120ºC
Maximum Junction Temperature (TJ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +150ºC
Surface Mount Solder Reflow Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C for 10 seconds
1. Never measure with CW source. Pulsed single-tone source with <50% duty cycle is recommended. Exceeding the maximum rating
of average output power could cause permanent damage to the device.
Operating Range
Range
Ambient Temp
VCC
Extended
-20 to +80ºC
2.9–3.5V
TABLE 2: DC Electrical Characteristics
Symbol Parameter
VCC Supply Voltage at pin 6
ICC Supply Current 2.4–2.5 GHz
Min.
Typ
3.0
12
Max.
Unit
V
mA
T2.0 1329
TABLE 3: AC Electrical Characteristics for Configuration
Symbol
FL-U
G
Parameter
Min.
2400
12
Typ
Max.
2550
13
Unit
MHz
dB
Frequency range
Small signal gain, 2.4–2.55 GHz
Noise Figure, 2.4–2.55 GHz
2.4–2.55 GHz
NF
1.14
1.5
dB
IIP3
3
dBm
T3.2 1329
©2006 Silicon Storage Technology, Inc.
S71329-00-000
9/06
4